Vermont Casting DVR28IN Operating Instructions, Glass Information, Window Frame Assembly Removal

Vermont Castings DVR28 Direct Vent Gas Fireplace

Operating Instructions

Glass Information

Only glass approved by CFM Corporation should be used on this fireplace.

•The use of any non-approved replacement glass will void all product warranties.

•Care must be taken to avoid breakage of the glass.

•Do not operate appliance with glass front removed, cracked or broken.

•Replacement glass (complete with gasket and window frame) is available through your CFM Corporation dealer and should only be installed by a licensed qualified service person.

Window Frame Assembly Removal

1.Turn the fireplace OFF (including the pilot).

2.If the unit has been operating, allow time for the components to cool.

3.Remove two (2) bolts on bottom side of unit holding front trim face on. (Fig. 32)

4.Remove front trim face by tilting bottom out and lift- ing face off unit. (Fig. 32)

5.Remove two (2) bolts securing bottom door frame to unit. (Fig. 31)

6.Tilt window frame assembly out slightly at the bot- tom, lift the frame up and away from the fireplace. (Fig. 31)

7.To replace window frame assembly reverse proce- dure.

Window Frame

Assembly

Fireplace

Front

Glass

Panel

FP1758

Fig. 31 Window frame assembly removal.

Glass Cleaning

It is necessary to clean the glass periodically. During start-up condensation, which is normal, forms on the inside of the glass and causes lint, dust and other airborne particles to cling to the glass surface. Also initial paint curing may deposit a slight film on the glass. It is therefore recommended the glass be cleaned

two or three times with a non-ammonia household cleaner and warm water (gas fireplace glass cleaner is recommended). After the initial cleaning process the glass should be cleaned two or three times during each operating season depending on the environment in the house.

Clean the glass after the first two weeks of operation.

Do not clean glass when hot.

Do not use abrasive cleaners.

Do not strike or slam the glass.

Removal and Re-fitting the Curve Face

The Curve face is fitted to the fireplace by hooking the top edge of the face over the mounting brackets as shown in Figure 32. Secure with two (2) screws on the bottom face of the trim. (Fig. 32)

Top Mounting

Brackets

Curve Face

Bottom Bracket

KT779 Control Cover Plate

Fig. 32 Hang Curve Face in place.

18 20012301