Zanussi ZCG 7691 manual Parts Required, Levelling the Appliance, Fitting the Stability Bracket

Page 47

INSTALLATION

1. PARTS REQUIRED

The loose hotplate parts are packed in the polystyrene fitment on top of the hotplate.

2. LEVELLING THE APPLIANCE

If the appliance requires levelling or its height adjusting (from the hotplate to any working surface), the procedure below must be followed:

1.Adjustment to suit floor conditions or height is obtained by rotating clockwise or anticlockwise the feet, at the front and rear of the appliance.

2.A spirit level should be placed on one of the oven shelves to confirm the appliance is correctly levelled.

3.FITTING THE STABILITY BRACKET

It is recommended that if the appliance is to be installed with a flexible supply pipe a stability bracket (SK.4729.A) is fitted and is available from your supplier (see Important Safety Requirements). These instructions should be read in conjunction with the leaflet packed with the stability bracket.

1.Place the appliance in its intended position and level appliance.

2.Mark off 300mm from the left hand side of the appliance as shown in dimension 'A', Fig 2a. This is the centre line of the fixing bracket.

3.Draw a line 100mm from the front edge of the levelling feet (see Fig.2a) and remove appliance from its position. Mark off dimension 'B' (see Fig.2a) back from this line on the centre line of the bracket to locate the front edge of the lower bracket. Fix lower bracket (with two fixing holes) to the floor then measure the height from floor level to engagement edge on back of appliance, dimension 'C' of Fig.2b.

4.Assemble upper bracket to lower bracket so that underside of bracket is dimension 'C' +3mm above floor level.

Reposition appliance and check that top bracket engages into appliance back as shown in Fig. 2b.

487mm (B)

100mm

(A)

300mm

(C)

Fig.2a

Fig.2b

47

Image 47

Contents ZCG Introduction For your safetyContents Further ignition of the burner Lighting the applianceHotplate Top oven Grill/top ovenGrill Oven light Main ovenTo turn off any burner Heat control Prior to using the grillGrill control has two heat settings GrillPositioning food on the grid Cooking positionsGeneral PreheatingGrill pan is supplied with a removable handle Grill pan and handleBurner sizes HotplateThan pans which are warped Take care to avoid burns and scalds when youAre reaching across the hotplate Use pans with flat bases. They are more stableHelpful hints Top oven You should turn food round during the cooking time OvensHeat zones Oven shelvesBaking trays and dishes Condensation RoastingOven cooking chart Main oven Mins. per ½kg 1lb and 25 mins 30 40 mins Base Well Done Oven cooking chart Top ovenBase Medium Lamb Shelf on MediumFruit pie shortcrust 25 35 mins Baked custard 50 60 mins 45 60 minsTurn the selector knob to Manual then turn to Clock Electronic timerTo use the Timer To set the time of dayEither direction Setting the controls for automatic useAutomatic control Clock. TurnTo cook? Cooked by? Switch off showsG 7 6 9 How long will Food takeHints and tips for automatic cooking Please note There is no slow cook on the top oven Slow cookingFood preparation slow cooking Left over food should be cooled quickly and refrigerated Do not cook casseroles over 2.7kg 6lbCover food with a tight fitting lid or tin foil Thaw thoroughly before cookingCleaning the handles and control knobs Care and cleaning For your safetyCap to crown When replacing hotplate burner partsGrill and oven furniture Ovens Main oven cleaning cycle Some staining will remain Top oven cleaning cycleTo remove the outer glass Cleaning between the outer and inner door glassLocation Cleaning The Door GlassInstalling the appliance Width 598mm Depth Appliance dimensionsPositioning Height to hotplate 900mm 920mmMoving your appliance General information For your safetyConnecting to the electricity supply Replacing the oven light bulb Check What is wrong and why?Probably a fault 7 0 5 9 2 9 9 2 Service and spare partsHigh Street Slough Berkshire Customer Care DepartmentInstallation Instructions Hotplate DimensionsConnections GrillGeneral Important Safety RequirementsMain Oven TOP OvenLocation of Appliance Fitting the Stability Bracket Parts RequiredLevelling the Appliance Connection to the Electricity Supply Connecting to GASChecking LID SHUT-OFF Device Pressure TestingChecking the Grill Checking the HotplateAutomatic Operation Checking the Main Oven ControlsChecking the Main Oven General Note Checking the TOP OvenChecking the Main Oven Light Standard guarantee conditions Guarantee ConditionsT E S G 7 6 9 1 T E S Part Number311733600