Zanussi ZDT40 user manual Care and cleaning, Cleaning the filters

Page 16

Water may appear on the sides and the door of the dishwasher as the stainless steel will eventually become cooler than the dishes.

CAUTION!

When the washing programme has finished, it is recommended that the dishwasher is un- plugged and the water tap turned off.

Care and cleaning

Cleaning the filters

IMPORTANT!

NEVER use the dishwasher without filters. In- correct repositioning and fitting of the filters will produce poor washing results.

Clean filters A, B and C thoroughly under running water.

Put the flat filter A back in

Replace the filters and

the base of the washing

lock by turning the handle

compartment and ensure

clockwise to the stop.

that it fits perfectly under

 

the two guidesD.

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

Turn the handle about 1/4

Remove filter A from the

turn anticlockwise and re-

base of the washing com-

move filters B and C.

partment.

16

Image 16
Contents ZDT40 Contents Safety information General safetyChild safety Correct useInstallation Control panelSetting mode Release the Programme selection/Can- cel buttonAudible signals Indicator lightsWashing programmes First useDegree of soil Type of loadClarke Water hardness Mmol/l Set the water softenerUse of salt Setting the water softener electronically see table Setting the water softener manually see tableWater hardness Clarke Mmol/l Use of dishwasher salt Use only special salt suitable for dishwashersFilling with rinse aid Adjusting the dosage of rinse aid Loading cutlery and dishesAre of limited suitability Adjusting the height of the upper basket Maximum height of the dishesUpper basket Lower basketUnloading the dishwasher Use of detergentDetergent tablets Care and cleaning Cleaning the filtersEnvironment concerns Fault code and malfunction Possible cause and solutionWhat to do if… Packaging materialWash results are not satisfactory Technical data Consumption valuesFull load 12 standard place settings Hints for test institutesWater connection InstallationInlet hose Drain hose Electrical connectionFitting under a counter LevellingPage Page Page 156991210-00-29112007