Water hardness
Clarke | °TH | mmol/l |
18 - 22 | 26 - 32 | 2,6 - 3,2 |
13 - 17 | 19 - 25 | 1,9 - 2,5 |
5 - 12 | 7 - 18 | 0,7 - 1,8 |
< 5 | < 7 | < 0,7 |
|
|
|
The water softener must be set in both ways: manually, using the water hardness dial and electronically.
Adjusting the water hardness
setting
manually |
| electronically |
1 |
| level 4 |
1 |
| level 3 |
1 |
| level 2 |
1 |
| level 1 |
|
|
|
Use of salt
yes yes yes no
Setting the water softener manually (see table)
The water softener is factory set at position 2.
Set switch to position 1 or 2
Setting the water softener electronically (see table)
1.Press the On/Off button. The appliance must be in setting mode.
2.Press and hold Programme selection/ Cancel button until programme light A flashes and programme light B illuminates with fixed light.
3.After a few seconds:
–programme light B turns off
–programme light A goes on flashing
–End of programme light starts flashing: the number of flashes corresponds to current level set. The flashing is repea- ted with a pause of a few seconds. Examples: 5 flashes, pause, 5 flashes, pause, etc... = level 5.
4.To change the level, press the Programme selection/Cancel button. Each time the button is pressed the level increases (level 1 follows level 10). The End of pro- gramme light indicates the new setting.
5.To memorise the operation, switch off the dishwasher.
9