Fault code and malfunction
The programme does not start.
Possible cause and solution
•The dishwasher door has not been properly closed. Close the door.
•The main plug is not plugged in. Insert the mains plug.
•The fuse has blown in the household fuse box. Replace the fuse.
Once these checks have been carried out; switch on the dishwasher. The programme will continue from the point at which it was inter- rupted.
If the malfunction or fault code reappears con- tact the Service Force Centre.
For other fault codes not described in the above chart, please contact your Service Force Cen- tre.
Mod. :. . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
PNC : . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
S.N. : . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
Contact your local Service Force Centre, quot- ing the model (Mod.), product number (PNC) and serial number (S.N.). This information can be found on the rating plate located on the side of the dishwasher door.. So that you always have these numbers at hand, we recommend you to make a note of them here:
The wash results are not satisfactory
The dishes are not clean
The dishes are wet and dull
•The wrong washing programme has been selected.
•The dishes are arranged in such a way as to stop water reaching all parts of the surface. The baskets must not be overloaded.
•The spray arms do not rotate freely due to incorrect arrangement of the load.
•The filters in the base of the washing compartment are dirty or incorrectly positioned.
•Too little or no detergent has been used.
•Where there are limescales deposits on the dishes; the salt container is empty or the incorrect level of the water softener has been set.
•The drain hose connection is not correct.
•The salt container cap is not properly closed.
•Rinse aid was not used.
•The rinse aid dispenser is empty.
19