Zanussi ZDT40 user manual What to do if…, Packaging material, Fault code and malfunction

Page 18

household waste disposal service or the shop where you purchased the product.

Packaging material

The packaging materials are environmentally friendly and can be recycled. The plastic com- ponents are identified by markings, e.g. >PE<, >PS<, etc. Please dispose of the packaging materials in the appropriate container at the community waste disposal facilities.

CAUTION!

When a unit is no longer being used:

Pull the plug out of the socket.

Cut off the cable and plug and dispose of them.

Dispose of the door catch. This prevents children from trapping themselves inside and endangering their lives.

What to do if…

The dishwasher will not start or stops during operation.

Certain problems are due to the lack of simple maintenance or oversights, which can be

solved with the help of the indications described in the chart, without calling out an engineer. Switch off the dishwasher and carry out the fol- lowing suggested corrective actions.

Fault code and malfunction

continuous flashing of the start/cancel indicator light

1 intermittent audible signal

1 flash of the "end of cycle" indicator light The dishwasher does not fill with water.

continuous flashing of the start/cancel indicator light

2 intermittent audible signals

2 flashes of the "end of cycle" indicator light The dishwasher will not drain.

continuous flashing of the start/cancel indicator light

3 intermittent audible signals

3 flashes of the "end of cycle" indicator light

Possible cause and solution

The water tap is blocked or furred with limescale. Clean the water tap.

The water tap is turned off. Turn the water tap on.

The filter (where present) in the threaded hose fitting at the water inlet valve is blocked.

Clean the filter in the threaded hose fitting.

The water inlet hose has not been correctly laid or it is bent or squashed.

Check the water inlet hose connection.

The sink spigot is blocked. Clean out the sink spigot.

The water drain hose has not been correctly laid or it is bent or squashed.

Check the water drain hose connection.

Anti-flood device is activated.

Close the water tap and contact your local Service Force Centre.

18

Image 18
Contents ZDT40 Contents Child safety Safety informationGeneral safety Correct useInstallation Control panelSetting mode Release the Programme selection/Can- cel buttonAudible signals Indicator lightsDegree of soil Washing programmesFirst use Type of loadSet the water softener Clarke Water hardness Mmol/lUse of salt Setting the water softener manually see table Setting the water softener electronically see tableWater hardness Clarke Mmol/l Use of dishwasher salt Use only special salt suitable for dishwashersFilling with rinse aid Adjusting the dosage of rinse aid Loading cutlery and dishesAre of limited suitability Upper basket Adjusting the height of the upper basketMaximum height of the dishes Lower basketUse of detergent Unloading the dishwasherDetergent tablets Care and cleaning Cleaning the filtersEnvironment concerns What to do if… Fault code and malfunctionPossible cause and solution Packaging materialWash results are not satisfactory Technical data Consumption valuesFull load 12 standard place settings Hints for test institutesInstallation Water connectionInlet hose Drain hose Electrical connectionFitting under a counter LevellingPage Page Page 156991210-00-29112007