Frigidaire 316257124, ES40 Removing and Replacing the Oven Door all models, To Remove Oven Door

Page 33

Care & Cleaning

Cleaning Recommendations for the Ceramic Glass Cooktop (cont’d)

Do not use the following on the ceramic glass cooktop:

•Do not use abrasive cleaners and scouring pads, such as metal and some nylon pads. They may scratch the cooktop, making it more

difficult to clean.

•Do not use harsh cleaners, such as chlorine bleach, ammonia or oven cleaners, as they may etch or discolor the cooktop.

• Do not use dirty sponges, cloths or paper towels, as they can leave soil or lint on the cooktop which can burn and cause discoloration.

Note: Additional cooktop cleaning cream may be ordered by visiting the

Frigidaire website at www.frigidaire.com

Fig. 1

Fig. 2

Fig. 3

Removing and Replacing the Oven Door (all models)

The door is heavy. For safe, temporary storage, lay the door flat with the inside of the door facing down.

To Remove Oven Door:

1.Open oven door completely (horizontal with floor - See Fig. 1).

2.Remove 2 screws located on the inside of the oven door liner (See A Fig. 2)

3.Insert the 2 screws into the door hinge holes located on the side of the hinge arm, one into each hinge (See B Fig. 2).

4.Close oven door until the door stops, (Do not force the door to close any further). The placement of these screws should keep door open in about a 45 degree position.

5.Grasp oven door firmly on both sides and slide door up and off hinges at the same angle. (See Fig. 3)

6.To clean oven door, follow the instructions provided in the Cleaning Chart at the beginning of the Care & Cleaning section (See Door Liner).

To Replace Oven Door:

1.Be sure the hinge arms remain at the 45 degree angle position. Be sure the screws are still locking the hinge arms from moving. If the screws fall out of the hinge holes, the hinge(s) may snap back against the oven frame and could pinch fingers or chip the porcelain finish on the oven front frame.

2.Hold door at the sides near the top while resting the lower front of door on your knee. Insert the door channels at the bottom of door over the door hinges, (See Fig. 3).

3.Allow the door to slide down into the door hinges evenly at the same 45 degree angle. The hinge arms should be inserted into the bottom corners as far as they can go.

4.Open door completely (horizontal with floor) and remove both screws from holes in door hinges.

5.Reinstall the 2 screws into the door liner (See C Fig. 2).

6.If the door is not in alignment with the oven frame, remove door and repeat the above steps.

33

Page 32 Page 34
Image 33
Page 32 Page 34
Contents Page Register Your Product Welcome & CongratulationsImportant Safety Instructions Read and Save These Instructions Features At a Glance Features At a Glance About the Ceramic Glass Cooktop Setting Surface ControlsAbout the Radiant Surface Elements Locations of the Radiant Surface Elements and ControlsAvailable Esec Display Settings Recommended Surface Cooking SettingsElectronic Surface Element Control Esec Esec Error Indicator Message Er Esec Hot Element Indicator Message HEEsec Lockout Feature Single Radiant Surface ElementsBridge Surface Radiant Element Dual Surface Radiant ElementTo Operate the Dual Surface Element Using Proper Cookware Surface CookingTo Operate the Bridge Surface Element Temperature Selection Operating the Warming ZoneTo Set the Warming Zone Control Arranging the Oven Racks Before Setting Oven ControlsAir Circulation in the Oven Oven Vent LocationSetting Warming Drawer Controls Settings Control Pad FeaturesMinimum and Maximum Control Pad Function follow later in this Use & Care ManualSetting the Clock Setting Oven ControlsTo set the clock example below for Changing between 12 or 24 hour time of day displaySetting Kitchen Timer Setting Continuous Bake or 12 Hour Energy SavingTo set the Kitchen Timer example for 5 minutes To cancel the Kitchen Timer before the set time has run outTo activate the Oven Lockout feature Setting Oven Lockout FeatureSetting Temperature Display Fahrenheit or Celsius To reactivate normal oven operationSetting Silent Control Operation To set the Preheat temperature for 350F Setting PreheatTo set the Bake Temperature to 350F Setting BakeSetting Timed Bake When the timed bake time runs outConv Roast or Conv Bake pads When the set bake time runs out Setting Delayed Time BakeBroiling Times To set the oven to broil at the default setting 550FConvection Roasting Instructions Setting Convection RoastTo set the oven for Convection Bake and temperature to 350F Setting Convection BakeGeneral Convection Bake Instructions Benefits of Convection BakePreparing for the Self-Clean Cycle Self-CleaningTo Start Self-Clean Cycle When the Self-Clean Cycle has completedStopping or Interrupting a Self-Cleaning Cycle To Start Delayed Self-Clean Cycle To Start Delayed Self-Clean Cycle cont’d Adjusting Oven TemperatureTo adjust the oven temperature higher To adjust the oven temperature lowerCare & Cleaning Surfaces How to CleanStainless Steel, Chrome Cleaning Recommendations for the Ceramic Glass Cooktop Cooktop Cleaning and MaintenancePlastic or foods with a high sugar content For light to moderate soilRemoving and Replacing the Oven Door all models To Remove Oven DoorTo Replace Oven Door Operating and Replacing the Oven Light Removing and Replacing the Warming Drawer some modelsBefore You Call Solutions to Common ProblemsSolutions to Common Problems cont’d Decrease Normal cook time by Cooking TablesPage Page Range Warranty
Top Page Image Contents