Grounding Instructions

essential for a good seal. Care should be taken not to rub, damage or move the gasket.

•Remove oven racks. Oven racks color will change if left in the oven during a self-cleaning cycle.

The health of some birds is

extremely sensitive to the fumes given off during the self-cleaningcycle of the range. Move the birds to another well ventilated room.

SAVE THESE INSTRUCTIONS

Grounding type

wall receptacle

Do not, under any

For personal safety, the cooktop must be properly grounded. For maximum safety, the power cord must be plugged into an electrical outlet that is correctly polarized and properly grounded.

DO NOT Operate the cooktop using a 2-prong adapter or an extension cord. If a 2-prong wall receptacle is the only available outlet, it is the personal responsibility of the consumer to have it replaced with a

properly grounded 3-prong wall receptacle installed by a qualified electrician.

See the INSTALLATION INSTRUCTIONS packaged with this cooktop for complete installation and grounding instructions.

circumstances, cut, remove, or bypass the grounding prong.

Power supply cord with 3-prong grounding plug

This appliance is equipped with a 3-prong grounding plug for your protection against shock hazard and should be plugged directly intoa properly grounded receptacle. DO NOT cut or remove the grounding prong from this plug.

Avoid fire hazard or electrical shock. DO NOT use an adapter plug, an extension cord, or remove grounding prong from electrical power cord. Fai[u reto follow this warning can cause serious injury, fire or death.

Conversion to Liquefied Petroleum Gas (or L.P. Gas)

This natural gas range is designed to allow for conversion to Liquefied Petroleum (L.P.) Gas.

If L.P. conversion is needed, contact the service center for assistance. The L.P. Conversion Kit is provided with this range and is located on the right panel (right side) of the range. Before installingthe kit be sure to followthe L.P. installation instructions carefully.

Personal injury or death from electrical shock

may occur if the range is not installed by a qualified installer or electrician.

Any additions, changes or conversions

required in order for this appliance to satisfactorily meet the application needs must be made by an authorized Service Center.