Care & Cleaning
To Remove and Replace Warm & Serve Drawer (some models)
Pull up latch
Left Glide (_
with finger
To remove Warm & Serve Drawer:
1.Turn power off before removing the Warm & Serve drawer.
2.Open the drawer to the fully opened position.
3.Locate the latches on both sides of the Warm & Serve drawer.
4.Pull up on the left glide latch and push down on the right glide latch.
5.Pull the drawer away from the range.
6.To clean Warm & Serve drawer, gently scour with a soapy scouring pad, this will remove most spots. Rinse with a 1:1 solution of clear water and ammonia. If necessary, cover difficult spots with an
To Replace Warm & Serve Drawer:
1. Align the glide latches on both sides of the drawer with the slots on the drawer.
2. | Push the drawer back into the range. |
Pull down latch | Right Glide | Electrical | Shock Hazard can occur and result | ||
with finger |
| in serious injury or death. Disconnect | appliance | from electric | |
Figure 1 |
| power before cleaning and servicing | the Warm | & Serve | drawer. |
To Remove and Replace Storage Drawer (some models)
Use the storage drawer for storing cooking utensils. The drawer can be removed to facilitate cleaning under the range. Use care when handling the drawer.
|
| Removing and Replacing | Storage | Drawer |
| Storage | To remove the drawer: |
|
|
Roller | Drawer | 1. Pull empty drawer out to the roller guide | stop. | |
2.Tilt the drawer up and pull it out over the rollers.
To replace the drawer:
1.insert the rear end of the drawer into the opening.
2.Fit the drawer end rollers onto the guide rails.
3.Push the drawer in until it stops, then lift to allow the rollers to clear the roller guide stop, and push in.
Front
Frame
18