At each channel, adjust the level as
2 desired until the sound level of each speaker is heard to be equally loud.
•You can select the desired channel and adjust its level with repeating the steps ① and ② in “Adjusting the current channel level” procedure.
Cancel the test tone function.
3
Adjusting the current channel level
•After adjusting each channel level with test tone, adjust the channel levels either according to the program sources or to suit your tastes.
•You can adjust the current channel levels as desired. These adjusted levels are just memorized into user’s memory(“USER”), not into preset memory(“REF. 1”, “REF. 2”).
Press the CHANNEL SELECTOR button.
1 | • Each time this button is pressed, “REF. 1” (or |
| “USER”) is displayed and the corresponding |
| channel is selected as follows: |
| < >: Possible only when the digital signals from Dolby Digital or DTS |
| program sources that include LFE signal are input. |
•Depending on the speaker setting and surround mode, etc., some channels cannot be selected.
•When the SPEAKER button is set to off, only the front L/R channel can be selected.
Adjust the level of the selected channel as
2 desired.
•The LFE level can be adjusted within the range of
•In general, we recommend the LFE level to be adjusted to 0 dB.(However, the recommended LFE level for some early DTS software is
•If the channel display disappears, start from the step ① again.
3
Repeat the above steps ① and ② to adjust each channel level.
32