Sherwood R-772 manual Dubbing from video components onto, Video

R-772(A)2007.8.165:21PM페이지46

ENGLISH

Dubbing from video components onto

VIDEO 1

1. Select the desired of VIDEO 2 ~ 4 as a recording source except VIDEO 1.

2. Start recording on the VIDEO 1.

3. Start play on the desired input.

•The audio and video signals from the desired input will be dubbed onto the VIDEO 1 and you can enjoy them on the TV set and from the speakers.

DIGITAL AUDIO RECORDING WITH MD RECORDER

•Only when the OPTICAL DIGITAL OUT of this receiver is connected to the OPTICAL DIGITAL IN of the MD recorder or CD recorder, you can enjoy high-quality sound of digital recording without converting the original signals. Refer to

"CONNECTING VIDEO COMPONENTS", "CONNECTING AUDIO COMPONENTS" and "CONNECTING DIGITAL INS and OUT" on pages 6~9 and the operating instructions of the MD recorder or CD recorder.

�Notes:

•Depending on the digital audio signal format input into the HDMI IN connector, some digital signals cannot be output from the OPTICAL DIGITAL OUT jack.

•Digital recording is available for the digital audio program sources such as CDs, MDs, some DVDs, etc.

•In most DVDs and SACDs as well as some CDs, etc., digital recording may not be available depending on the signal format.

•There are some restrictions on recording digital signals. When making digital recordings, refer to the operating instructions of your digital recording equipment to know what restrictions are imposed.

1. Select the desired of CD, AUX, VIDEO 1~4 as a recording source.

�In case of recording the digital audio signal input into a HDMI IN connector

•Select the desired recording source to which the HDMI IN is connected and assigned and then perform the steps 3 and 4 (, but ignore the step 2).

�Note :

•If the AUDIO MODE is set to the mode other than "HDMI" for the corresponding recording source on the INPUT SETUP menu, the digital audio signals will not be output and there will be no recording. (For details, refer to "When selecting the AUDIO MODE" on page 54.)

2. For digital recording, select the digital input as recording signal input.

�Note :

•If the AUDIO MODE is set to the mode other than "DIGITAL" for the corresponding recording source on the INPUT SETUP menu, the digital audio signals from the selected digital input will not be output and there will be no recording. (For details, refer to "When CD, AUX, VIDEO 1~ 4 is selected as an input source" on page 31 and "When selecting the AUDIO MODE" on page 54.)

3.Start recording on the component connected to the OPTICAL DIGITAL OUT.

4.Start play on the desired input.

46