Frigidaire FPEF4085KF Minimum and Maximum Control PAD Settings, Setting the Clock

Page 15

SETTING MAIN OVEN CONTROLS

MINIMUM AND MAXIMUM CONTROL PAD SETTINGS

All of the features listed below have minimum and maximum time or temperature settings that may be entered into the control. An ENTRY acceptance beep will sound each time a control pad is touched (the acceptance beep on the Oven Lockout pad is delayed 3 seconds).

An ENTRY ERROR tone (3 short beeps) will sound if the entry of the temperature or time is below the minimum or above the maximum settings for the feature.

FEATURE

 

MINIMUM TEMP. /TIME MAXIMUM TEMP. /TIME

BAKE

 

170°F/77°C

550°F/288°C

BROIL

 

400°F/205°C

550°F/288°C

CONVECTION BAKE

 

170°F/77°C

550°F/288°C

CONVECTION ROAST

 

170°F/77°C

550°F/288°C

TIMER

12 Hr. Mode

0:01 Min.

11:59 Hr./Min.

 

24 Hr. Mode

0:01 Min.

11:59 Hr./Min.

CLOCK TIME

12 Hr. Mode

1:00 Hr./Min.

12:59 Hr./Min.

 

24 Hr. Mode

0:00 Hr./Min.

23:59 Hr./Min.

DELAY START

12 Hr. Mode

1:00 Hr./Min.

12:59 Hr./Min.

 

24 Hr. Mode

0:00 Hr./Min.

23:59 Hr./Min.

COOK TIME

12 Hr. Mode

0:01 Min.

11:59 Hr./Min.

 

24 Hr. Mode

0:01 Min.

11:59 Hr./Min.

SELF CLEAN TIME

 

2 hours

4 hours

SETTING THE CLOCK

The SET CLOCK pad is used to set the clock. The clock may be set for 12 or 24 hour time of day operation. The clock has been preset at the factory for the 12 hour operation. When the range is first plugged in, or when the power supply to the range has been interrupted, the timer in the display will flash.

To set the clock (example below for 1:30)

1.Press SET CLOCK. “CLO” will appear in the display.

2.Press 1 3 0 pads to set the time of day to 1:30. “CLO” will stay in the display.

3.Press START. “CLO” will disappear and the clock will start.

CHANGING BETWEEN 12 OR 24 HOUR TIME OF DAY DISPLAY

1.Press and hold SET CLOCK for 7 seconds.

2.After 7 seconds, “12h” or “24h” will appear in the display and the control beep once.

3.Press SELF CLEAN to switch between the 12 and 24 hour time of day display. The display will show either “12h” or “24h”.

4.Press START to accept the change or press CANCEL to reject the change.

5.Reset the correct time as described in To set the Clock above. Please note that if the 24 hour time of day mode was chosen, the clock will now display time from 0:00 through 23:59 hours.

SETTING CONTINUOUS BAKE OR 12 HOUR ENERGY SAVING

The TIMER and SELF CLEAN pads control the Continuous Bake or 12 Hour Energy Saving features. The oven control has a factory preset built-in 12 Hour Energy Saving feature that will shut off the oven if the oven control is left on for more than 11 hours and 59 minutes. The oven can be programmed to override this feature for Continuous Baking.

To set the control for Continuous Bake or 12 Hour Energy Saving features

1.Press and hold TIMER for 7 seconds. After 7 seconds “12h” or “- -h will appear in the display and the control will beep once.

2.Press SELF CLEAN to switch between the 12 Hour Energy Saving and continuous bake features. Note: “12h” in the display indicates the control is set for the 12 Hour Energy Saving mode and “- -h indicates the control is set for the Continuous Bake feature.

3.Press START to accept the change (display will return to time of day) or press CANCEL to reject the change.

15

Image 15
Contents Use &Care Welcome & Congratulations Register Your ProductPlease Carefully Read and Save These Instructions Definitions Important Safety InstructionsKnow which knob controls each surface heating unit Important Instructions for Using Your CooktopImportant Safety Instructions for Using Your Oven Important Safety Instructions for Cleaning Your OvenFor Glass Cooktop only Your built-in range Features Features AT a GlanceAbout the ceramic glass cooktop Before Setting Surface ControlsElement on & hot surface indicator lights Surface Cooking SettingsCookware material types Using proper cookwareSetting Surface Controls Single radiant surface elementsTo Operate the Single Radiant Surface Elements Figure To Operate the Dual Surface Element Dual Surface Radiant ElementTo Operate the Bridge Surface Element Bridge surface radiant elementKeep warm zone Keep warm zone recommended food settings table Food ItemArranging oven racks Before Setting Oven ControlsOven vent location Air circulation in the ovenControl pad features Setting Main Oven ControlsFeature Minimum TEMP. /TIME Maximum TEMP. /TIME Minimum and Maximum Control PAD SettingsSetting the Clock Setting Continuous Bake or 12 Hour Energy SavingSetting Temperature Display Fahrenheit or Celsius Setting Minute TimerSetting Lockout Feature Setting Silent Control OperationSetting Bake Setting Convection BakeStart Convection Roasting Tips Setting Convection RoastSetting Convection Convert To set a Convection Roast Temperature of 375FPress START. TIMED, Bake and 350 will remain in the display Setting Bake TimeSetting Delay Start When the timed bake finishesElectric Oven Broiling Table Recommendations Setting BroilCancel Broiling TipsTo set Keep Warm Setting Keep WarmSetting MY Favorite Keep Warm TipsSetting the Sabbath Feature To toggle the Oven Lights on and OFF Adjusting Oven TemperatureTo adjust the oven temperature higher To adjust the oven temperature lowerSELF-CLEANING Adhere to the following cleaning precautionsWhat to Expect during Cleaning Setting SELF-CLEAN Cycle Time Length To Start the Delayed SELF-CLEAN CycleWhen the Self-Clean Cycle is Completed Rack Position From Top Food Setting Auxiliary Oven ControlsTo Bake To BroilSurfaces How to Clean Cleaning various parts of your appliancePorcelain enamel oven Cleaning auxiliary oven Care & CleaningFor heavy, burned on soil Ceramic glass cooktop cleaning & maintenanceCleaning recommendations for the ceramic glass cooktop For light to moderate soilTo Remove Oven Door Care and cleaning of stainless steelPlastic or foods with a high sugar content Aluminum utensilsChanging oven light Be Sure Oven is CoolTo Replace the Light Bulb To remove and replace storage drawer with extendible glide Oven baking Occurrence Possible CAUSE/SOLUTION Discoloration with Self-cleaning cycleSoil not completely removed after self- cleaning cycle AreasMajor Appliance Warranty Exclusions This warranty does not cover the followingDisclaimer of Implies Warranties Limitation of Remedies