3-Wire Power Cord Installation using Strain Relief Supplied
(See Figures 3.1 and 3.2)
1.Remove the Terminal Block Access Plate on the back of the range by unscrewing the 4 fixing Screws.
2.Insert the Power Cord through the Bracket; then tighten the Power Cord by using the Strain Relief. Allow enough slack to easily attach the cord terminals to the Terminal Block.
3.Remove the 3 wire terminal nuts and washers from the Terminal Block.
4.Plug the terminal holes of Power Cord. The Neutral or Ground Wire of the Power Cord must be connected to the neutral terminal located in the center of Terminal Block. The Power Wires must be connected to the outside terminals.
5.Plug washers and tighten nuts securely.
Do not remove Ground strap.
6.Assemble the Terminal Block Access Plate.
4-Wire Power Cord Installation using Strain Relief Supplied
(See Figures 3.1 and 3.3)
1.Remove the Terminal Block Access Plate on the back of the range by unscrewing the 4 fixing Screws (fig. 3.1).
2.Insert the Power Cord through the Bracket; then tighten the Power Cord by using the Strain Relief. Allow enough slack to easily attach the cord terminals to the Terminal Block.
3.Remove the 3 wire terminal nuts and washers from the Terminal Block.
4.Remove the Ground Strap from the frame of range and ter- minal by removing its screw and cutting it as shown in Figure 3.3.
5.Plug the terminal holes of Power Cord. The Neutral Wire of the Power Cord must be connected to the neutral terminal located in the center of Terminal Block; the Power Wires
must be connected to the outside terminals; the Ground Wire must be attached to the frame of range by using the 
(Ground) identified Grounding Screw.
6.Plug washers and tighten nuts securely.
7.Assemble the Terminal Block Access Plate.
Screws | Fig. 3.1 |
| |
Terminal Block |
|
Access Plate |
|
Fig. 3.2 |
Terminal Block |
Ground strap |
Neutral Wire |
Power Wires |
Bracket |
Power Cord |
Strain Relief |
| Fig. 3.3 |
Terminal Block | Cut Ground Strap |
| Grounding Wire |
Neutral Wire |
|
Power Wires |
|
Bracket | Grounding Screw |
| Power Cord |
Strain Relief |
|
17