DeLonghi DEGESC24SS GAS Connection Specification, Extension, Pressure regulator

Page 11

GAS CONNECTION SPECIFICATION

Range

manifold

1/2” G cylindrical (ISO 228-1) male

Manifold male pipe fitting

Gasket

 

1/2” G cylindrical

 

 

 

 

 

(ISO 228-1) female

 

 

 

 

Extension

pipe female pipe fitting

 

Extension

 

pipe

Extension

 

pipe male

1/2” G cylindrical

pipe fitting

(ISO 228-1) male

Gasket

1/2” G cylindrical

 

(ISO 228-1) female

1/2” NPT (conical)

Connector

male

 

1/2” NPT female

To range

To mains

connection

Pressure regulator

1/2” NPT female

Arrow

WARNING: check the right positioning of the gas regulator. The arrow on the back of the gas regulator must be oriented toward the connector.

Fig. 2.4

11

Image 11
Contents GAS/ELECTRIC Range ALL Ranges can TIP Data Plate Conversion Label Installation Instructions Air Supply and Ventilation Replacement PartsElectrical Grounding Instructions Electrical RequirementGAS and Electric Connection Proximity to Side CabinetsAssembling the Backguard It is mandatory to install the backguardLevelling the Range ANTI-TIP Stability Device Installation InstructionsPressure Regulator Manual Shut-off Valve figExplosion Hazard Pressure Regulator Installation Step Pressure regulator GAS Connection SpecificationExtension Rigid Pipe Connections Leak TestingFlexible Connections To remove the warming drawer Setting the Pressure Regulator figConversion to LP/PROPANE GAS Fitting the warming drawer fig To set the pressure regulator figInjectors Table Operations to be Performed When Substituting the InjectorsSetting the Burner Minimum Electrical Connection with Conduit Electrical Connection with Power CordElectrical Requirements Wire Power Cord Installation using Strain Relief Supplied Wire Power Cord Installation Wire Conduit Installation Energy Regulator Wiring DiagramPage Page Page Cod ß4