Tilt-Lock (stand-up) Units
(on models so equipped)
You can lift a
To reposition the tilt-lock unit:
●Replace the drip pan/trim ring into the recess in the cooktop.
●If you have a separate trim ring, put it in place over the drip pan. The drip pan must be under the trim ring.
●Guide the surface unit into place so it rests evenly.
Plug-In Units
(on models so equipped)
&!!i5!s
Lift a
Do not lift a
Repeated lifting of the
Separate Drip Pan & Trim Ring
Installation/Removal
/
To replace a plug-in unit:
●Replace the drip pan into the recess in the cooktop. Make sure opening in pan lines up with receptacle. If you have a separate trim ring, put it in place over the drip pan. The drip pan must be under the trim ring.
●Insert the terminals of the
●Guide the surface unit into place so it rests evenly.
Note: The drip pan must be under the trim ring.
CAUTION
●Do not attempt to clean
●Do not immerse
●Do not bend the
●Do not attempt to clean, adjust or in any way repair the
Adjusting Oven Thermostat
Use the time given in your recipe when using the oven for the first time. Oven thermostats. in tilme, may “drift” from the factory setting and differences in timing between an old and a new oven of 5 to 10 minutes are not unusual. Your oven has been set correctly at the factory and is more likely to be accurate than the oven which it replaced. However, if you find that your foods consistently brown too little or too much, you may make a simple adjustment in the thermostat (Oven Temp) knob.
@ | III* |
@ | @ |
8“ PER NOT ‘+
To adjust the thermostat knob:
1.Pull the knob off the shaft, look at the back of the knob and note the current setting before making any adjustments.
2.Loosen both screws on the back of the knob.
3.If the oven temperature seems too hot, move the top screw toward the word HOTTER. If the temperature seems too cool, move the screw toward the word COLDER. Each notch changes the temperature by about 8 degrees Fahrenheit.
4.Tighten the screws.
5.Replace the knob, matching the flat area of the knob to the shaft.
23
— —