GE JBP24GP Operating the Self-Cleaning Oven, Before Setting Oven Controls, Check These Things

Page 20

Operating the Self-Cleaning Oven

Normal cleaning time: 3 hours

Before Setting Oven

Controls, Check These

Things:

Step 1:

Remove broiler pan, broiler rack and other cookware from the oven. (Oven shelves may be left in oven. NOTE: Shelves will discolor during the self-clean cycle. )

Step 2:

Wipe up heavy soil on oven bottom. If you use soap, rinse thoroughly bef’ore self-cleaning, to pre~ent staining.

A. Oven Front Frame

B. Oven Door Gasket

C. Openings in Door

D. Oven Light

Step 3:

Clean spatters or spills on oven front flame (A) and oven door outside gasket (B) with a dampened cloth. Polish with a dry cloth. Do not clean gasket (B). Do not allow water to run down through openings in top of door (C). Never use a commercial oven cleaner in or around self-cleaning oven.

Clean top, sides and outside front of oven door with soap and water. Do not use abrasives or oven cleaners.

Step 4:

Close oven door and make sure oven light (D) is off.

Caution: Chrome trim rings around the surface units should never be cleaned in the self-cleaning oven. Neither should reflector pans of foil or shiny chrome.

How to Set Oven for Cleaning

Step 1:

Turn OVEN SET and OVEN TEMP knobs to CLEAN. Controls will snap into final position when the CLEAN location is reached.

Step 2:

. Slide the latch handle to the right as far as it will go.

Step 3:

Set the automatic oven timer:

. Make sure both the clock and the DELAY START dial show the correct time of day. When the DELAY START knob is pushed in and turned, it will “pop” into place when the time shown on the clock is reached.

s Push in and turn STOP TIME knob. Set Stop Time for three hours later than present time of day—for example, if it is 6:00 now, set Stop Time for 9:()().

The oven cycling light (below OVEN TEMP knob). the CLEANING light and the OVEN ON light will glow, indicating that the self-clean cycle has begun. When the oven reaches a certain temperature, the oven door will lock. The latch handle cannot be moved until oven cleaning is complete and the oven cools down. Oven door and window (on models so equipped) get hot during self- clean cycle. DO NOT TOUCH.

The oven will smoke the first time you use the self-clean cycle even though you have wiped up any excessive soil. This is normal and should stop in about 10 minutes. To help control the smoke, turn on the exhaust fan over the range when you use the self-clean cycle the first time.

20

Image 20
Contents Self-Cleaning Electric Range Save time and money. Before you request service If you need serviceHelp us help you If you received Damaged rangeImportant Safety Instructions Read all instructions before using this applianceImportant Safety Instructions Self-Cleaning OvenOven Surface Cooking UnitsInstalling Your Range Energy-Saving TipsLeveling the Range Surface CookingFeatures of Your Range TJBP22PFeature Index not all models have all features ExplainedHow to Set the Controls Dial settings may differSurface Cooking See Surface Cooking GuideObserve Following Points in Canning Questions & AnswersHome CanningTqs Surface Cooking Guide Cookware Tips~n~o~ ere~ Automatic Timer and Clock Using Your Oven How to Set Your Range for Baking How to Time BakeHow to Set Delay Start and Stop On models with this featureBaking Guide Bread 400-4750 15-20For Frozen Roasts Why is my roast crumbling when I try to carve it?Roasting Roasting Guide Frozen roasts can beWhy should I leave the door closed when broiling chicken? BroilingUse of Aluminum Foil Questions & AnswersBroiling Guide Beef SteaksHow to Set Oven for Cleaning Operating the Self-Cleaning OvenBefore Setting Oven Controls, Check These Things Follow These Steps after Self-Cleaning Care and Cleaning Plug-In Units Adjusting Oven ThermostatTilt-Lock stand-up Units Cleaning Guide General DirectionsSoap and Water Use This Problem Solver Questions?Before YOU Begin ~ ~s appbce must be prope~ @unddStep PRE*RE for Electriul Connection Muminum Wiring Step IRE System Special Grounding InstructionsPage Wdll Be There Warranty