GE JSP60GN manual Set a Delayed Start, To Stop a Clean Cycle, Push Stop Time button

Page 31

;O Set a Delayed Start

Delay Start is setting the oven timer to start the clean cycle automatically at a later time than the present time of day.

NOTE: Before beginning, make sure the oven clock shows the correct time of day.

Quick Reminder:

1.Prepare oven for cleaning.

2.Slide the oven door latch to the right as far as it will go.

3.Push the STOP TIME button.

4.Set the desired time you want the oven to stop. Turn the SET knob clockwise until the Stop Time you desire appears in the display.

5.Push the CLEAN button.

6.Turn the SET knob 1/2 turn. Time that appears is 3X hours before the Stop Time you select.

For example: Let’s say it’s 7:00 and you want the oven to begin self-cleaning at 10:30 after you’re finished in the kitchen. The oven is soiled a normal mount so the normal Clean Time of 3 X hours is

.“eferred.

1.Prepare the oven for cleaning.

2.Close the oven door and make sure the light is off.

Slide the latch handle to the right as far as it will go.

3.Push STOP TIME button.

4.Turn the SET knob to time of day when you wish cleaning to be completed (must be more than 3X hours later than current time of day).

5.Push the CLEAN button.

6.Turn the SET knob in a clockwise direction about 1/2 turn.

The words “DELAY CLEAN” will be on in the display until the clean cycle starts. After the clean cycle starts, the word “CLEAN” will be on in the display.

7.When the word “LOCK” is not displayed, and the oven has cooled, slide the latch handle to the left as far as it will go and open the oven door.

Never force the latch handle. Wait

until the word “LOCK” goes out

 

 

●

in the display and the latch slides

 

 

 

easily. Forcing the latch handle

ZZ

may damage the door lock.

1

 

 

 

 

NOTE: During a delayed self-clean

operation, you can find out when the oven will begin the self-clean cycle by pushing and holding the CLEAN button.

NOTE:

●You can find out when the clean cycle will be finished by pushing the STOP TIME button.

●The word “ DOOr” is displayed when you try to set the clean cycle with the door open or when the oven temperature is too high.

●Clean Time is normally 3 X hours. Y@trcm c na@ the~i ean k~ rs

dep~wdk%y-t~ G!ti’1 04 ,

T

●If “F-” and a number flash on the display, and the control beeps, this indicates a function error code. Press the CANCEL button. Allow oven to cool for 1 hour. Put oven back into operation. If function error code repeats, disconnect power to the range. Call for service.

●If the self-cleaning mode malfunctions, turn off and disconnect the power supply. Have serviced by a qualified technician.

To Stop a Clean Cycle

1.Press the CANCEL button.

2.Wait until the oven has cooled below locking temperature and the word “LOCK” is off in the display. You will not be able to open the door right away unless the oven temperature is at a safe level.

(eofzfitiueci tfext page)

31

Page 30 Page 32
Image 31
Page 30 Page 32
Contents
Use and Care &Installation Guide Accessories Save time and money. Before you request serviceIf you received a damaged range or modular com-ponents Described in this manual Use this appliance only for its intended use asSurface Cooking Modules Self-Cleaning OvenSafety Instructions OvenLeveling the Range Installing the RangeSave These Instructions Features of Your Modular GRILL/GRIDDLE Range Cooktop ModulesLower Compartment Surface Cooking How to Set the ControlsHeat Setting Guide Downdraft Cooktop Modules Vent SystemCooking Tips OokwareDeep Fat Frying Wok CookingHome Canning Tips Observe the Following Points in CanningFlat-bottomed canners are recommended Care of Modules Modules and AccessoriesCookware How to Check Pan Performance on a Module ElementCookware Tips for Module Cooking Elements Jw to Insert the Module How to Remove the ModuleOpen Coil Module Questions & Answers Solid Disk Module Before Using Your Solid Disk Module for the First TimeHow to Insert the Module General Information About Solid Disk ElementsMelted Materials on the Module OW to Insert the ModuleTo insert the grill How to Assemble the Grill ModuleGeneral Information About Grill Modules Grill ModuleDo not leave grill unattended while it is in use Questions and AnswersCan my grill be switched to the other side of the range? Grill TipsBeef Steaks, tender To i inch Grill Cooking GuideUsing the Griddle How to Assemble the Griddle AccessoryHow to Remove Griddle Accessory Do I need special cookware for use with my griddle? Griddle AccessoryHow should I store my griddle when it is not in use? Griddle TipsTo 1/2 inch Griddle Cooking GuideShelf Positions Adjusting the Oven ThermostatUsing Your Oven Oven ShelvesTo Set the Clock To Set the TimerAutomatic Oven Timer To Cancel the TimerTones To Delay Starting an Automatic Oven OperationHow to Change a Program Oven CONTROL, Clock and TimerType of Food Shelf Position Iow to Set Your Range for BakingPreheating Baking PansPies Pan PlacementBaking Guides Cookies Roasting Guide Frozen Roasts Approximate Roasting Time Should I salt the meat before broiling? Why are my meats not turning out as brown as they should?Use of Aluminum Foil Questions & AnswersBrush with melted butter before Oven door should be open to the broil stop positionHow to Set the Oven for Cleaning Before a Clean CycleOperating SELF-CLEANING Oven Never force the latch handle. Wait Set a Delayed StartTo Stop a Clean Cycle Push Stop Time buttonWhy do I have ash left in my oven after cleaning? After a Clean CycleOperating the SELF-CLEANING Oven Should there be any odor during the cleaning?Plug-In Elements of the Open Coil Module Clean the area under the drip pans oftenDrip Pans Solid Disk Element Module Care and CleaningRemoval of Packaging Tape General Information Radiant ModuleFor heavy, burned on soil Special CareGrill Module Griddle AccessoryPorcelain Enameled Grease Wells Brushed Chrome FinishPull out vent grills and lift out aluminum grease filters Module CoverChrome Module Surfaces Removable Downdraft Vents and Grease FiltersOven Light Bulb Broiler Pan and RackGrease Jars Inside of door Tiift-Off Oven DoorOven Vent Duct To remove the doorMetal Parts Cleaning Under the RangeControl Panel Control KnobsNotb Mti-Tip DeviceQUESTIONS? USE this Problem Solver Problem Problem Solver Page Page We’ll Be There Warranty
Top Page Image Contents