GE 164D3333P159, 49-8927 owner manual Wire Conduit Installation

Page 43

6 3-Wire Conduit Installation

Remove the 3 screws from the connector block. Insert bare wires between the connector block terminals and movable nuts. Tighten screws securely. Do not remove ground strap connection.

WARNING: Connector block is approved for copper wire connection only. If aluminum wire is used, see note below.

NOTE: ALUMINUM WIRING

a Do not connect aluminum wire to the connector block.

Use copper building wire rated for the correct amperage and voltage to make 3 (three) 3″ copper jumper wires. Connect wire as per Step 6 or 7 depending on number of wires.

b Splice copper wires to aluminum wiring using special connector terminals designed and UL-approved for joining copper to aluminum and follow the connector manufacturer’s recommended procedure closely.

Wire used, location and enclosure of splices, etc., must conform to good wiring practices and local codes.

Screw
Connector block	Bare wire tips
Connector block terminal

Bare wire

Movable nut

Flexible cable

Bracket	Conduit

Safety Information Operating Instructions Installation Instructions Troubleshooting Tips Customer Service

43

Image 43

Contents GE Answer Center RangeCongratulations You Are Now Part of Our Family Staple sales slip or cancelled check hereWrite the model and serial numbers here Customer Service Safety InformationInstallation Instructions Troubleshooting TipsAll ranges can tip and injury could result Important Safety NoticeSafety Precautions Safety Information Cook Meat and Poultry THOROUGHLY… Instructions Troubleshooting Tips Customer ServiceOven SELF-CLEANING Oven on some models Surface UNITS-ALL Models Radiant Surface Units on some models Coil Surface Units on some models Customer Service TroubleshootingHow to Set Using the surface unitsAbout the radiant surface units… Using the radiant surface units on some modelsPorcelain Enamel Covered Cast Iron Stainless SteelAluminum Copper BottomWok Cooking Surface Cookware TipsClock and Timer Features Using the oven controlsAllow the oven to be left on for more than 12 hours Using the oven controls. on some modelsBoth the MIN. +/- pads for about 4 seconds How to Set the Oven for Baking or Roasting Using the ovenOven Temperature Knob on some models Troubleshooting Tips Customer ServiceHow to Set the Oven for Broiling Preheating and Pan PlacementAluminum Foil Comments Broiling guideUsing the clock and timer. on some models Press Cook Time ON/OFF Using the timed baking Roasting features. on some modelsHow to Set an Immediate Start Automatic Stop How to Set a Delay Start and Automatic StopFor Self-Cleaning Models with Only an Oven Temperature Knob Adjust the oven thermostat-Easy to do yourselfType of margarine will affect baking performance To Adjust the Thermostat on Standard Clean ModelsBefore a Clean Cycle Using the self-cleaning oven on some modelsHow to Set the Oven for Cleaning After a Clean Cycle How to Delay the Start of CleaningPress the Start Time ON/OFF pad Oven Interior non-self clean models Care and cleaning of the rangeTo clean the outside of the door To clean the inside of the doorLift-Off Oven Door To remove the cover Oven Light Replacement on some modelsOven Heating Elements Oven ShelvesTo replace the storage drawer How to Remove the Storage Drawer to Clean Under the RangeBroiler Pan & Grid To remove the storage drawerNational Parts Center Cleaning the glass cooktopDaily Cleaning For heavy, burned-on soilSpecial Care Lift-Up Cooktop on some models Porcelain Enamel Cooktop on some modelsTo replace a surface unit To remove a surface unitOven Vent Control Panel and KnobsPainted Surfaces Before You Begin Installation of the rangePrepare the Opening Prepare for Electrical Connection Flooring Under the RangePower Cord Strain Relief Installation Wire Power Cord Installation Before After Wire Conduit Installation Screw Leveling the Range Anti-Tip Bracket InstallationFinal Check Before you call for service… Oven-All Models Coil Cooktops Surface unitsNot functioning ProperlyBroil properly At Broil Food does not bakeOr roast properly Food does notWhen range is Oven temperatureClock and timer Blank or indicatorA number Power outageFlash in the display When you wanted Self-Cleaning Models Oven will notSelf-clean Self-clean cycleAfter a clean cycle Clean lightIs on when you Oven not cleanSafety Information Customer Service Two Years Electric Range WarrantyFor The Period We Will Replace One YearIn-Home Repair Service 800-GE-CARES Service Telephone NumbersTDD 800-TDD-GEAC