GE 49-8927, 164D3333P159 owner manual Screw

Page 44

Customer Service Troubleshooting Tips Installation Instructions Operating Instructions Safety Information

Installation of the range.

Read these instructions completely and carefully.

7 4-Wire Conduit Installation

Remove the 3 screws from the connector block. Remove the grounding strap from the connector block middle location and the screw connecting it to the frame of the range. Insert bare wires between the connector block terminals and movable nuts. Tighten screws securely. Attach ground wire to the frame of the range.

WARNING: Connector block is approved for copper wire connection only. If aluminum wire is used, see note below.

NOTE: ALUMINUM WIRING

a Do not connect aluminum wire to connector block.

Use copper building wire rated for the correct amperage and voltage to make 3 (three) 3″ copper jumper wires. Connect wire as per Step 6 or 7 depending on number of wires.

b Splice copper wires to aluminum wiring using special connector terminals designed and UL-approved for joining copper to aluminum and follow the connector manufacturer’s recommended procedure closely.

Wire used, location and enclosure of splices, etc., must conform to good wiring practices and local codes.

	Screw	Bare wire tips
	Connector block	Bare wire tips
	Connector block
	Connector block terminal
Bare wire		Grounding
Bare wire		plate
Movable nut	Flexible cable
	Flexible cable
	Bracket	Conduit
		Conduit

44

Image 44

Contents Range GE Answer CenterWrite the model and serial numbers here Staple sales slip or cancelled check hereCongratulations You Are Now Part of Our Family Safety Information Installation InstructionsTroubleshooting Tips Customer ServiceImportant Safety Notice All ranges can tip and injury could resultSafety Precautions Safety Information Instructions Troubleshooting Tips Customer Service Cook Meat and Poultry THOROUGHLY…Oven SELF-CLEANING Oven on some models Surface UNITS-ALL Models Radiant Surface Units on some models Customer Service Troubleshooting Coil Surface Units on some modelsUsing the surface units How to SetUsing the radiant surface units on some models About the radiant surface units…Stainless Steel AluminumCopper Bottom Porcelain Enamel Covered Cast IronSurface Cookware Tips Wok CookingUsing the oven controls Clock and Timer FeaturesBoth the MIN. +/- pads for about 4 seconds Using the oven controls. on some modelsAllow the oven to be left on for more than 12 hours Using the oven Oven Temperature Knob on some modelsTroubleshooting Tips Customer Service How to Set the Oven for Baking or RoastingAluminum Foil Preheating and Pan PlacementHow to Set the Oven for Broiling Broiling guide CommentsUsing the clock and timer. on some models Using the timed baking Roasting features. on some models How to Set an Immediate Start Automatic StopHow to Set a Delay Start and Automatic Stop Press Cook Time ON/OFFAdjust the oven thermostat-Easy to do yourself For Self-Cleaning Models with Only an Oven Temperature KnobTo Adjust the Thermostat on Standard Clean Models Type of margarine will affect baking performanceHow to Set the Oven for Cleaning Using the self-cleaning oven on some modelsBefore a Clean Cycle Press the Start Time ON/OFF pad How to Delay the Start of CleaningAfter a Clean Cycle Care and cleaning of the range Oven Interior non-self clean modelsLift-Off Oven Door To clean the inside of the doorTo clean the outside of the door Oven Light Replacement on some models Oven Heating ElementsOven Shelves To remove the coverHow to Remove the Storage Drawer to Clean Under the Range Broiler Pan & GridTo remove the storage drawer To replace the storage drawerCleaning the glass cooktop Daily CleaningFor heavy, burned-on soil National Parts CenterSpecial Care Porcelain Enamel Cooktop on some models Lift-Up Cooktop on some modelsTo remove a surface unit To replace a surface unitPainted Surfaces Control Panel and KnobsOven Vent Installation of the range Before You BeginPrepare the Opening Flooring Under the Range Prepare for Electrical ConnectionPower Cord Strain Relief Installation Wire Power Cord Installation Before After Wire Conduit Installation Screw Final Check Anti-Tip Bracket InstallationLeveling the Range Before you call for service… Coil Cooktops Surface units Not functioningProperly Oven-All ModelsFood does not bake Or roast properlyFood does not Broil properly At BroilOven temperature Clock and timerBlank or indicator When range isFlash in the display Power outageA number Self-Cleaning Models Oven will not Self-cleanSelf-clean cycle When you wantedClean light Is on when youOven not clean After a clean cycleSafety Information Customer Service Electric Range Warranty For The Period We Will ReplaceOne Year Two YearsTDD 800-TDD-GEAC Service Telephone NumbersIn-Home Repair Service 800-GE-CARES