GE JGB920 Burner Caps and Heads, Burner caps, Burner heads, After cleaning, Replacement

Page 33

www.GEAppliances.com

Safety

Burner Caps and Heads

NOTE: Before removing the burner caps

and heads, remember their size and location. Replace them in the same location after cleaning. The top sides of the Right Front, Right Rear and Left Front burner heads are marked with the letters “RF,” “RR” and “LF,” respectively, to aid reassembly.

Burner caps

Lift off when cool. Wash burner caps in hot, soapy water and rinse with clean water. You may scour with a plastic scouring pad to remove burned-on food particles.

Burner heads

The slits in the burner heads of your cooktop must be kept clean at all times.

Clogged or dirty burner ports or electrodes will not allow the burner to operate properly.

Any spill on or around an electrode must be carefully cleaned. Take care to not hit an electrode with anything hard or it could be damaged.

You should clean the burner caps, burner heads and burner bases routinely, especially after bad spillovers, which could clog the openings in the burner heads. Lift off when cool.

To remove burned-on food, soak the burner heads in a solution of mild liquid detergent and hot water for 20–30 minutes. For more stubborn stains,

use a toothbrush.

After cleaning

Before putting the burner caps and heads back, shake out excess water and then dry them thoroughly by setting in a warm oven for 30 minutes.

NOTE: Do not use steel wool or scouring powders to clean the burners or electrodes. This can damage the burners and electrically short the electrodes.

Replacement

The top sides of the Right Front, Right Rear and Left Front burner heads are marked with the letters “RF,” “RR” and “LF,” respectively, to aid reassembly.

Medium head

 

(not marked)

Small head

and cap

and cap

 

RR

LF

RF

 

Front of range

Large head

Extra large

and cap

head and

 

cap

Replace the burner heads on the bases matching the letters. Replace the caps on the heads. Make sure that the caps and heads are replaced in the correct location. There is one small, one medium, one large and one extra large head and cap.

Locator pins

Pin slots

Instructions Operating Instructions Installation Instructions Troubleshooting Tips

When replacing, make sure the locator pins in the burner head are seated in the pin slots of the burner base. Rotate the burner head around the burner base until it is level and securely seated.

33

Consumer Support

Image 33
Contents Write the model and serial numbers here Model # Serial # Installation InstructionsANTI-TIP Device Consumer Support TroubleshootingSafety Instructions Operating Instructions Important Safety NoticeInstructions Surface Burners Installation Instructions Operating Instructions Safety Consumer Support Troubleshooting TipsCook Meat and Poultry THOROUGHLY… Troubleshooting Tips ConsumerUsing the gas surface burners Troubleshooting Tips InstallationInstructions Operating Consumer Support Installation Instructions Troubleshooting TipsOven Control, Clock and Timer Features on some models Using the oven controlsOven Light Pad on some models Troubleshooting Tips Consumer SupportUsing the oven Installation Instructions OperatingTroubleshooting Tips Preheating and Pan Placement How to Set the Oven for Baking or RoastingAluminum Foil Oven MoistureBroiling Guide How to Set the Oven for BroilingBroiling Guide HI BroilTo Set the Timer Using the clock and timerTo Reset the Timer To Cancel the TimerConsumer Support Troubleshooting Tips Installation Using the timed baking and roasting featuresHow to Set an Immediate Start and Automatic Stop How to Set a Delayed Start and Automatic StopHow to Set the Oven For Cooking When Using the Probe Using the probe. on some modelsInstallation Instructions Operating Instructions Safety Using the convection oven. on some modelsConvection Bake Convection RoastHow to Set the Oven for Convection Baking or Roasting Troubleshooting Tips Consumer SupportMulti-Shelf Baking Touch the Convection Bake orTouch the Convection Roast pad Operating Instructions SafetyConvection Roasting Guide Using the timed convection baking features. on some models Installation Instructions Operating InstructionsTouch the Convection Bake pad Safety Instructions Special features of your oven controlFahrenheit or Celsius Temperature Selection Hour Shut-OffControl Lockout on some models Cook and HoldCooking function is finished Instructions Troubleshooting Tips Consumer Support Using the Sabbath FeatureHow to Set for Regular Baking/Roasting Designed for use on the Jewish Sabbath and HolidaysHow to Exit the Sabbath Feature Safety Instructions Adjust the oven thermostat-Do it yourselfTo Adjust the Thermostat Type of margarine will affect baking performanceWhen Using the Warming Drawer Using the electric warming drawer. on some modelsWarming drawer cannot be used during a self-clean cycle To Use the Warming DrawerTemperature Selection Chart Instructions Operating Instructions InstallationTo Crisp Stale Items To Warm Serving Bowls and PlatesConsumer Support Troubleshooting Tips Installation Using the self-cleaning ovenBefore a Clean Cycle How to Set the Oven for CleaningHow to Delay the Start of Cleaning After a Clean CycleSealed Burner Assemblies Care and cleaning of the rangeReplacement After cleaningBurner Caps and Heads Burner capsBurner Grates CleaningTo Order Do not use a steel-wool pad it will scratch the surfaceNormal Daily Use Cleaning Cleaning the glass cooktop. on some modelsBurned-On Residue Heavy, Burned-On ResidueCooktop Seal Damage from Sugary Spills and Melted PlasticTo Order Parts Lift-Off Oven Door Troubleshooting TipsOven Bottom Broiler Pan and GridWarming Drawer Pan on some models Removable DrawerTo remove the drawer To replace the drawer Unlock the touch pads after cleaning Safety Instructions OperatingOven Air Vents Upper Control PanelOven Shelves Oven Light ReplacementTo remove Do not remove any screws to remove the coverFor Your Safety Tools YOU will NeedMaterials YOU MAY Need Electrical Connections in this section Installation InstructionsMinimum Wall on Either side Dimensions and ClearancesLocation ANTI-TIP DeviceConnect the Range to GAS Provide Adequate GAS SupplyGAS Pipe and Electrical Outlet Locations Rigid Pipe Hookup Options Flexible Connector HookupElectrical Requirements Electrical ConnectionsCheck Ignition of Surface Burners Seal the OpeningsCheck Ignition of Oven Burner To remove the oven bottom Leveling the RangeWhen ALL Hookups are Completed Installing the ANTI-TIP DeviceBefore You Call For Service… Oven temperature Control signals afterClock and timer Entering cooking timeAfter a clean cycle Oven not clean after a See the Using the self-cleaning oven sectionClean cycle Is on when you wantDisplay goes blank Power outageDisplay flashes Unable to getLooking For Something More? AccessoriesWe’ll Cover Any Appliance. Anywhere. Anytime Consumer Product Ownership Registration Operating Instructions Installation Instructions Troubleshooting Tips Installation Instructions Safety Instructions What GE Will Not Cover GE Will ReplaceUnder the warranty Safety Instructions Operating InstructionsCamco Will Replace What Camco Will Not CoverConsumer Support GE Appliances Website Schedule Service
Related manuals
Manual 64 pages 49.5 Kb

JGB920 specifications

The GE JGB920 is a top-of-the-line gas range that embodies advanced features and modern cooking technologies, making it a favorite among culinary enthusiasts and home cooks alike. One of its standout characteristics is the powerful stainless steel construction, which not only delivers a sleek and professional look but also ensures durability and easy maintenance.

One of the primary features of the GE JGB920 is its convection oven, which uses a fan to circulate hot air, providing even cooking results for all dishes. This technology is especially beneficial for baking, as it aids in creating consistent browning and prevents hot spots. Additionally, the oven boasts a generous capacity, allowing users to prepare multiple dishes simultaneously or accommodate larger roasts.

The JGB920 also features a variety of cooking modes, including bake, broil, and even specialized settings like a self-cleaning function. This feature automates the cleaning process, using high temperatures to eliminate food residues, thus simplifying post-cooking cleanup.

The range is equipped with a precise temperature control system, allowing for accurate adjustments for various cooking methods. The integrated electronic ignition ensures a reliable start-up, while the gas burners provide responsive heat adjustment, enabling users to achieve the desired cooking temperatures efficiently.

Another significant aspect of the GE JGB920 is its Smart technology capability. By connecting to a home network, users can control the range remotely via a smartphone app. This feature allows for preheating the oven or adjusting cooking settings from the comfort of another room, adding convenience to the cooking process.

The cooktop itself is designed with versatility in mind. It offers multiple burner sizes, including a powerful high-heat burner for boiling and a simmer burner for delicate sauces. This flexibility meets various cooking demands, from searing to simmering, enhancing the range's overall functionality.

Safety is also a priority in the design of the GE JGB920. The range includes a variety of safety features, such as a gas safety valve and a child lock, ensuring peace of mind for families.

In summary, the GE JGB920 gas range successfully combines innovative cooking technologies with user-friendly features and a stylish design. Its convection oven, smart technology integration, and versatile cooktop options make it an excellent choice for any kitchen, elevating the cooking experience to new heights.