GE JGB920 installation instructions Installing the ANTI-TIP Device, When ALL Hookups are Completed

Page 51

Installation Instructions

9INSTALLING THE ANTI-TIP DEVICE

WARNING!

Range must be secured with an approved Anti- Tip device.

Unless properly installed, the range could be tipped by you or a child standing, sitting or leaning on an open door.

After installing the Anti-Tip device, verify that it is in place by carefully attempting to tilt the range forward.

This range has been designed to meet all recognized industry tip standards for all normal conditions.

The use of this device does not preclude tipping of the range when not properly installed.

If the Anti-Tip device supplied with the range does not fit this application, use the universal Anti-Tip device WB2X7909.

A.Mark the wall where the RIGHT EDGE of the range is to be located. Be sure to allow for the countertop overhang if you intend to install the range next to cabinets.

 

Anti-Tip

 

device

Slotted head

 

screw

Wallplate

 

Approx. 20°

 

2 18Marked edge of range

B. Locate the outside edge of the device 218″ toward the center of the range from the marked edge of the range.

C. Using the device as a template, mark the position of the hole for the screw.

D. For wood construction, drill a pilot hole at an angle of 20 degrees from the horizontal. A nail or awl may be used if a drill is not available.

Mount the Anti-Tip device with the screw provided.

For cement or concrete construction, you will need a 1/4″ x 112″ lag bolt and a 1/2″ O.D. sleeve anchor, which are not provided. Drill the recommended size hole for the hardware.

9INSTALLING THE ANTI-TIP DEVICE (CONT.)

Wallboard

Back of range

 

Anti-Tip device

Wood screw

Install the sleeve anchor into the drilled hole and then install the lag bolt through the device. The bolts must be properly tightened as recommended for the hardware.

E. Slide the range against the wall, and check for proper installation by grasping the front edge of the cooktop and carefully attempting to tilt the range forward.

WHEN ALL HOOKUPS ARE

COMPLETED

Make sure all controls are left in the off position. Make sure the flow of combustion and ventilation air to the range is unobstructed.

CONVERTING TO LP GAS (or

converting back to natural gas from LP)

This range leaves the factory set for use with natural gas. If you want to convert to LP gas, the conversion must be performed by a qualified LP gas installer.

The conversion instructions and LP orifices can be found attached to the range next to the pressure regulator.

Keep these instructions and the orifices in case you want to convert back to natural gas.

51

Image 51
Contents Write the model and serial numbers here Model # Serial # Installation InstructionsANTI-TIP Device Consumer Support TroubleshootingSafety Instructions Operating Instructions Important Safety NoticeInstructions Surface Burners Installation Instructions Operating Instructions Safety Consumer Support Troubleshooting TipsCook Meat and Poultry THOROUGHLY… Troubleshooting Tips ConsumerUsing the gas surface burners Troubleshooting Tips InstallationInstructions Operating Consumer Support Installation Instructions Troubleshooting TipsOven Control, Clock and Timer Features on some models Using the oven controlsOven Light Pad on some models Troubleshooting Tips Consumer SupportUsing the oven Installation Instructions OperatingTroubleshooting Tips Oven Moisture How to Set the Oven for Baking or RoastingPreheating and Pan Placement Aluminum FoilHI Broil How to Set the Oven for BroilingBroiling Guide Broiling GuideTo Cancel the Timer Using the clock and timerTo Set the Timer To Reset the TimerHow to Set a Delayed Start and Automatic Stop Using the timed baking and roasting featuresConsumer Support Troubleshooting Tips Installation How to Set an Immediate Start and Automatic StopHow to Set the Oven For Cooking When Using the Probe Using the probe. on some modelsConvection Roast Using the convection oven. on some modelsInstallation Instructions Operating Instructions Safety Convection BakeTouch the Convection Bake or Troubleshooting Tips Consumer SupportHow to Set the Oven for Convection Baking or Roasting Multi-Shelf BakingTouch the Convection Roast pad Operating Instructions SafetyConvection Roasting Guide Using the timed convection baking features. on some models Installation Instructions Operating InstructionsTouch the Convection Bake pad Hour Shut-Off Special features of your oven controlSafety Instructions Fahrenheit or Celsius Temperature SelectionControl Lockout on some models Cook and HoldCooking function is finished Designed for use on the Jewish Sabbath and Holidays Using the Sabbath FeatureInstructions Troubleshooting Tips Consumer Support How to Set for Regular Baking/RoastingHow to Exit the Sabbath Feature Type of margarine will affect baking performance Adjust the oven thermostat-Do it yourselfSafety Instructions To Adjust the ThermostatTo Use the Warming Drawer Using the electric warming drawer. on some modelsWhen Using the Warming Drawer Warming drawer cannot be used during a self-clean cycleTo Warm Serving Bowls and Plates Instructions Operating Instructions InstallationTemperature Selection Chart To Crisp Stale ItemsHow to Set the Oven for Cleaning Using the self-cleaning ovenConsumer Support Troubleshooting Tips Installation Before a Clean CycleHow to Delay the Start of Cleaning After a Clean CycleSealed Burner Assemblies Care and cleaning of the rangeBurner caps After cleaningReplacement Burner Caps and HeadsDo not use a steel-wool pad it will scratch the surface CleaningBurner Grates To OrderHeavy, Burned-On Residue Cleaning the glass cooktop. on some modelsNormal Daily Use Cleaning Burned-On ResidueCooktop Seal Damage from Sugary Spills and Melted PlasticTo Order Parts Broiler Pan and Grid Troubleshooting TipsLift-Off Oven Door Oven BottomWarming Drawer Pan on some models Removable DrawerTo remove the drawer To replace the drawer Upper Control Panel Safety Instructions OperatingUnlock the touch pads after cleaning Oven Air VentsDo not remove any screws to remove the cover Oven Light ReplacementOven Shelves To removeFor Your Safety Tools YOU will NeedMaterials YOU MAY Need Electrical Connections in this section Installation InstructionsMinimum Wall on Either side Dimensions and ClearancesLocation ANTI-TIP DeviceConnect the Range to GAS Provide Adequate GAS SupplyGAS Pipe and Electrical Outlet Locations Rigid Pipe Hookup Options Flexible Connector HookupElectrical Requirements Electrical ConnectionsCheck Ignition of Surface Burners Seal the OpeningsCheck Ignition of Oven Burner To remove the oven bottom Leveling the RangeWhen ALL Hookups are Completed Installing the ANTI-TIP DeviceBefore You Call For Service… Entering cooking time Control signals afterOven temperature Clock and timerIs on when you want See the Using the self-cleaning oven sectionAfter a clean cycle Oven not clean after a Clean cycleUnable to get Power outageDisplay goes blank Display flashesLooking For Something More? AccessoriesWe’ll Cover Any Appliance. Anywhere. Anytime Consumer Product Ownership Registration Operating Instructions Installation Instructions Troubleshooting Tips Installation Instructions Safety Instructions What GE Will Not Cover GE Will ReplaceWhat Camco Will Not Cover Safety Instructions Operating InstructionsUnder the warranty Camco Will ReplaceConsumer Support GE Appliances Website Schedule Service
Related manuals
Manual 64 pages 49.5 Kb

JGB920 specifications

The GE JGB920 is a top-of-the-line gas range that embodies advanced features and modern cooking technologies, making it a favorite among culinary enthusiasts and home cooks alike. One of its standout characteristics is the powerful stainless steel construction, which not only delivers a sleek and professional look but also ensures durability and easy maintenance.

One of the primary features of the GE JGB920 is its convection oven, which uses a fan to circulate hot air, providing even cooking results for all dishes. This technology is especially beneficial for baking, as it aids in creating consistent browning and prevents hot spots. Additionally, the oven boasts a generous capacity, allowing users to prepare multiple dishes simultaneously or accommodate larger roasts.

The JGB920 also features a variety of cooking modes, including bake, broil, and even specialized settings like a self-cleaning function. This feature automates the cleaning process, using high temperatures to eliminate food residues, thus simplifying post-cooking cleanup.

The range is equipped with a precise temperature control system, allowing for accurate adjustments for various cooking methods. The integrated electronic ignition ensures a reliable start-up, while the gas burners provide responsive heat adjustment, enabling users to achieve the desired cooking temperatures efficiently.

Another significant aspect of the GE JGB920 is its Smart technology capability. By connecting to a home network, users can control the range remotely via a smartphone app. This feature allows for preheating the oven or adjusting cooking settings from the comfort of another room, adding convenience to the cooking process.

The cooktop itself is designed with versatility in mind. It offers multiple burner sizes, including a powerful high-heat burner for boiling and a simmer burner for delicate sauces. This flexibility meets various cooking demands, from searing to simmering, enhancing the range's overall functionality.

Safety is also a priority in the design of the GE JGB920. The range includes a variety of safety features, such as a gas safety valve and a child lock, ensuring peace of mind for families.

In summary, the GE JGB920 gas range successfully combines innovative cooking technologies with user-friendly features and a stylish design. Its convection oven, smart technology integration, and versatile cooktop options make it an excellent choice for any kitchen, elevating the cooking experience to new heights.