Verona VEFSGE 304 SC ANTI-TIP Stability Device Installation Instructions, Levelling the Range

1

LEVELLING THE RANGE

The range is equipped with 4 LEVELLING FEET and may be levelled by screwing or unscrewing the feet (figs. 1.6 - 1.7).

It is important to observe the directions of figures 1.6, 1.8a, 1.8b.

Fig. 1.6

Supplied with the range	Supplied with the range
in a separate kit	in a separate kit

		0”		+ 5/16”
		0 mm
				+ 8 mm
		+ 5/16”		+ 11/16”
		+ 8 mm	Fig. 1.8a		Fig. 1.8b
				+ 17.5 mm
Fig. 1.7
YOU MUST USE STABILITY		ANTI-TIP STABILITY DEVICE INSTALLATION INSTRUCTIONS
ANTI TIP	BRACKET TO	1. The anti-tip bracket has to be attached as shown on figure below (only rear left side),
PREVENT	UNIT FROM	it has to be fixed on the floor OR on the rear wall by no. 4 (four) suitable screws (not
TIPPING.		supplied). Alternatively the anti-tip bracket can also be fixed on the floor AND on the
		rear wall by no. 8 (eight) suitable screws (not supplied).

2.After fixing the anti-tip bracket, slide range into place. Be sure the rear left foot slides under the anti-tip bracket attached.

Dotted line showing the position

ANTI-TIP STABILITY of the range when installed

DEVICE FIXING

3” 15/64 (82 mm)

Anti-tip stability device

Rear left feet of range

10

Fig. 1.9