Verona VEFSGE 304 SC manual Pressure Regulator Installation Step

Page 13

2

PRESSURE REGULATOR INSTALLATION

STEP 1

Mount the 1/2” NPT (conical) male connector to the pressure regulator and

tighten by using a wrench.LOCK Do not over tighten the connector.

Over tightening may crack regulator.

Arrow

Fig. 2.2

STEP 2

Assemble the 1/2” NPT connector + pressure regulator group to the extension pipe interposing the gasket supplied. The regulator cover must be oriented toward the front side of the range.

IMPORTANT: use two wrenches to tighten the connection.

Gasket

Regulator cover

Fig. 2.3

 

13

Image 13
Contents GAS/ELECTRIC Range What to do if YOU Smell GAS Data Plate Conversion Label Installation Instructions Electrical Grounding Instructions Replacement PartsProximity to Side Cabinets InstallationAssembling the Backguard It is mandatory to install the backguardProximity to Side Cabinets Standard Installation Proximity to Side Cabinets Island Installation Levelling the Range ANTI-TIP Stability Device Installation InstructionsInstalling the Cooktop Front Guard Pressure Regulator Manual Shut-off Valve figExplosion Hazard Pressure Regulator Installation Step GAS Connection Speficication Flexible Connections Leak TestingRigid Pipe Connections To set the pressure regulator fig Setting the Pressure RegulatorInjectors Table Operations to be Performed When Substituting the InjectorsSemirapid burner Setting the Burner MinimumElectrical Requirements Electrical Connection with Power CordElectrical Connection with Conduit =1 9/64 29 mm =7/8 22.5 mm Power Cord Wire Power Cord Installation See FigurePlug the terminal holes of conductors Wire Conduit Installation See FigureElectric Diagram KEY Wiring Diagram