Southbend S536D, X560AA, X536D, X536A, S560DD, X560AD, S560AA Specifications, Clearances, Dimensions

Page 4

SPECIFICATIONS

500 SERIES RESTAURANT RANGES

SPECIFICATIONS

NOTICE

Local codes regarding installation vary greatly from one area to another. The National Fire Protection Association, Inc., states in its NFPA 96 latest edition that local codes are the “authority having jurisdiction” when it comes to installation requirements for equipment. Therefore, installations should comply with all local codes.

Southbend reserves the right to change specifications and product design without notice. Such revisions do not entitle the buyer to corresponding changes, additions, or replacements for previously purchased equipment.

Southbend appliances are intended for commercial use only, not for household use.

The installation must conform with local codes, or in the absence of local codes, with the National Fuel Gas Code, ANSI Z223.1, Natural Gas Installation Code, CAN/CGA-B149.1,or the Propane Installation Code CAN/CGA- B149.2, as applicable, including:

1.The appliance and its individual shutoff valve must be disconnected from the gas supply piping system during any pressure testing of that system at test pressures in excess of 1/2 psi (3.45 kPa).

2.The appliance must be isolated from the gas supply piping system by closing its individual manual shutoff valve during any pressure testing of the gas supply piping system at test pressures equal to or less than 1/2 psi (3.45 kPa).

CLEARANCES

WARNING

MINIMUM CLEARANCES FROM COMBUSTIBLE CONSTRUCTION

There must be adequate clearance between ranges and combustible construction. Clearance must also be provided for servicing and for operation.

Minimum Clearances:

 

 

 

 

Standard Oven

Convection Oven

Double Oven Base

Sides

10 inches

10 inches

10 inches

Back

10 inches

10 inches

10 inches

Floor

zero

zero

zero

Ranges are suitable for installation on combustible floors.

Adequate clearance must be provided in the aisle and at the side and rear to allow the door to open sufficiently to permit the removal of the racks and for serviceability.

On ranges with a convection-type oven, a minimum of 2 inches clearance must be allowed behind the motor and the rear non-combustible enclosure. Care must be taken to provide adequate air circulation to prevent the motor from overheating. No additional clearance from the sides and back is required for service as the ranges are serviceable from the front.

DIMENSIONS

The exterior dimensions of the restaurant range are shown in Figure 2 on the next page.

PAGE 4 OF 44

OWNERS MANUAL 1188716 (02/07)

Image 4
Contents Restaurant Ranges Safety Precautions Introduction Location of Serial PlateDimensions SpecificationsClearances Dimensions Interior Dimensions and Utility Data VentilationGAS Supply Electrical RequirementsOperation Lighting After GAS has Been Shut OFFOperation of TOP Burners Operation of OvenTroubleshooting CONVECTION-OVEN Cooking Problems Troubleshooting by OperatorShutdown of Entire Range Cooking Tips for Convection Ovens Cleaning & Maintenance Daily CleaningCleaning Oven Interior Periodic Cleaning and MaintenanceSTAINLESS-STEEL Surfaces BRIGHT-ANNEALED STAINLESS-STEEL SurfacesInstallation UnpackingUnpacking Installation of LegsAttach Legs Installation of Casters Attach Casters and RestraintInstallation of Restraint Installation of Flue Riser and Shelf Assembly Attach Flue Riser and Shelf AssemblyElectrical Connection for CONVECTION-OVEN Models only GAS ConnectionSHUT-DOWN and WIPE-CLEAN Range Check the InstallationCheck Operation Service Troubleshooting FLOWCHARTS, PROCEDURES, and Wiring DiagramsTroubleshooting Open-Top Burners Troubleshooting OPEN-TOP BurnersTroubleshooting Oven Pilot Troubleshooting Base OvenTroubleshooting CONVECTION-OVEN Blower Convection-Oven Blower Runs IntermittentlyConvection-Oven Blower Does Not Run Is there continuity? Yes Continue on nextAdjustment of GAS Pressure Regulator Check That Power is Disconnected AT Circuit BreakerAdjustment of OPEN-TOP Pilots Adjustment of OPEN-TOP BurnersAdjustment of Oven Standing Pilot Adjustment of Oven BurnerCalibration of Oven Thermostat Thermostat Calibration and Bypass Flame Adjustment Conversion from ONE Type of GAS to AnotherWiring Diagram for 115 Volt Models Wiring Diagram for 208-230 Volt Models Leg and Caster Parts PartsExternal Panel and Drip Pan Parts Flue Riser and Shelf Parts Open-Top Burner Parts for X500 Models 1187489Open-Top Burner Parts for S500 Models Piezo Spark Module Parts 1186454Convection Oven Parts See parts list on previous 2221 Standard Oven Parts See parts list on previous VALVE, GAS Shutoff NIPPLE, Pipe REGULATOR, Pressure Series Restaurant Ranges Series Restaurant Ranges Series Restaurant Ranges Restaurant Ranges

X560DD S536A, S560AD, S560AA, X560AD, S536D specifications

Southbend, a well-established name in the commercial kitchen equipment industry, offers a variety of high-quality cooking appliances, including the X560AA, X536D, X536A, S560DD, and S536D models. Each of these models is designed to meet the rigorous demands of professional kitchens while delivering exceptional performance.

The Southbend X560AA is a robust gas range featuring six heavy-duty burners, a large oven, and a durable stainless steel construction. Its powerful burners provide precise temperature control, making it ideal for a wide range of cooking techniques from simmering to high-heat frying. The oven is spacious enough to accommodate large trays, enabling efficient cooking of multiple items simultaneously. This model also boasts an easy-clean design, ensuring that maintenance and upkeep are hassle-free.

The X536D model is distinguished by its unique combination of an oven and a griddle, offering versatility without sacrificing quality. Equipped with a powerful charbroiler, the X536D allows chefs to prepare a variety of dishes simultaneously, making it a perfect addition to busy kitchens. Its intuitive controls facilitate quick adjustments, and the griddle's non-stick surface ensures consistent cooking results.

Similarly, the Southbend X536A combines an oven with a unique steam cooking feature, ideal for steaming vegetables and seafood while retaining essential nutrients. This model includes advanced safety mechanisms and ergonomic controls that enhance user experience. The X536A stands out for its energy efficiency, which not only reduces operational costs but also promotes environmentally friendly practices.

The S560DD and S536D are part of Southbend's heavy-duty series, designed for increased durability and performance. The S560DD features double ovens, allowing for simultaneous cooking at different temperatures, which is crucial for maximizing productivity in the kitchen. It includes high-efficiency burners that provide quick heat-up times and reduce gas consumption.

The S536D is renowned for its exceptional versatility, featuring six burners, a spacious oven, and a practical griddle top. Designed for high-output cooking, it's ideal for restaurants and catering services that require speed and efficiency. All models come with user-friendly controls, easy cleanup features, and solid construction that meet the high standards of professional chefs.

In summary, Southbend's X560AA, X536D, X536A, S560DD, and S536D models exemplify the brand's commitment to quality, innovation, and performance. Equipped with advanced technologies, these ranges are not only reliable but also adaptable to the dynamic needs of commercial kitchens, ensuring that chefs can focus on creativity and culinary excellence.