Parkinson Cowan SONATA 50GX Levelling the Appliance, Fitting the Stability Bracket

Page 38

2. LEVELLING THE APPLIANCE

Adjustable levelling feet at the front and at the rear are provided on the base of the appliance.

Adjustment to suit floor conditions is obtained by rotating in or out the hexagonal feet from the underside of the appliance.

A spirit level should be placed on one of the oven shelves to confirm that the appliance is correctly levelled.

3.FITTING THE STABILITY BRACKET

It is recommended that if the appliance is to be installed with a flexible supply pipe a stability bracket (SK.4729.A) is fitted and is available from your supplier (see Important Safety Requirements, Page 36). These instructions should be read in conjunction with the leaflet packed with the stability bracket.

1.Place the appliance in its intended position and level appliance.

2.Mark off 250mm from the left hand side of the appliance as shown in dimension 'A', Fig 3a. This is the centre line of the fixing bracket.

3.Draw a line 100mm from the front edge of the levelling feet (see Fig 3a) and remove appliance from

its position. Mark off dimension 'B' (see Fig 3a) back from this line on the centre line of the bracket to locate the front edge of the lower bracket. Fix lower bracket (with two fixing holes) to the floor then measure the height from floor level to engagement edge on back of appliance, dimension 'C' of Fig. 3b.

4.Assemble upper bracket to lower bracket so that underside of bracket is dimension 'C' +3mm above floor level. (see Fig. 3b).

Reposition appliance and check that top bracket engages into appliance back as shown in Fig. 3b.

200m

 

 

487mm (B)

100mm

(C)

 

 

 

(A)

 

 

250mm Fig.3a

 

Fig3.b

4. CONNECTING TO GAS

This appliance is designed to be installed with an appliance flexible connection only. Supply piping should not be less that R³/8. Connection is made to the Rc ½ (½" B.S.P.) female threaded entry pipe located just below the hotplate level on the rear left hand side of the appliance. NOTE: ONLY LIQUID SEALANTS TO

BE USED WHEN INLET GAS PIPE IS FITTED TO RESET VALVE I.E.: DO NOT USE P.T.F.E. SEALANT TAPE.

Check for gas soundness after connecting the gas supply.

The gas bayonet connector must be fitted in the shaded area indicated in Fig. 4. Take into account that it must be possible to pull the appliance forward sufficiently. The hose must not get caught on the stability bracket.

IMPORTANT: FLEXIBLE TUBING USED MUST COMPLY WITH BS. 669 CURRENT EDITION.

L.P.G. FLEXIBLE CONNECTIONS MUST BE OF A TYPE SUITABLE FOR L.P.G. AND CAPABLE OF OPERATION UP TO 50 mbar AND TO CARRY A RED STRIPE, BAND OR LABEL.

38

Image 38
Contents Owners handbook Installation Instructions For your safety IntroductionContents Hotplate Leave the grill door open when you are using the grillLighting the cooker Grill/second ovenOpen the oven door Second ovenMain oven To turn off any burner Cooking positions GrillHeat control Children should be kept awayPutting food on the grid GeneralPreheating Hotplate Burner sizesFor your safety Helpful hints Oven shelves OvensHeat zones Around the food Shelf on base Baking trays and dishesCondensation Page ½kg 1 lb Mins. per ½kg 1 lb and 25 minsMins. per ½kg 1 lb and 15 mins Large 25 35 minsOn baking tray Fruit pie shortcrust 25 35 minsMince pies flan pastry 15 25 mins Puddings Milk puddingsOven cooking chart Second oven 180mm Yorkshire puddingMins Cakes Christmas cake Shelf ½ hours Fruit pie shortcrust MinsBaked custard 50 60 mins Page N a T a 5 0 G Soups, casseroles and stews Thaw thoroughly before cookingCare and cleaning For your safety Grill and second oven When replacing hotplate burner partsClean the grill and oven frequently using hot soapy water Check for ignitionFollow the oven cleaning cycle regularly Oven cleaning cycle Cleaning between the outer and inner door glass To remove the outer glassEnsure that a stability bracket is fitted Installing the cooker For your safetyLocation For further details seeHeight to hotplate 902mm 920mm Cooker dimensionsPositioning Width 498mm DepthMoving your cooker General information For your safetyBattery Reversing the oven door What is wrong and why? CheckN a T a 5 0 G Problem Servicing For your safety Gas Consumers CouncilInstallation Instructions Ignition DimensionsConnections GrillImportant Safety Requirements Provision for VentilationLocation of Appliance Parts RequiredFitting the Stability Bracket Connecting to GASLevelling the Appliance Checking the Grill Fitting the BatteryPressure Testing Checking the HotplateGeneral Note Checking the Main OvenChecking the Second Oven N a T a 5 0 G Sonata 50GX/2 Contents Check List Description