Avery 7112 HF user manual Regular Maintenance, Series Hopper Feed

Page 17

Regular Maintenance

7112 Series Hopper Feed

1.Remove accumulated moisture form the air filter by opening the bleed valve located at the base of the filter bowl.

2.To check the sealing area for an out of parallel condition: with the heat on, set the timer for one (1) second or less; place a light colored cloth or paper on the base plate; put a piece of carbon paper, carbon down on the cloth, and run the machine through a cycle. The carbon paper will leave a picture of the sealing area on the cloth. THE COLOR SHOULD BE EVEN. A dark area indicates more pressure in that area and should be corrected.

3.If the out of level condition is either in the front or back, the base plate can be tilted. Loosen the bolt to lower the front and raise the back. Tighten to raise the front, lower the back.

4.If it is side to side, it must be corrected with shims placed under the base plate insulator block.

5.Light or dark spots within the sealing area will indicate that either of the plates may be warped. This would require surface grinding by a machine shop. (Make certain that the vacuum arm does not extend lower than the electrode.)

6.Lubricate the head assembly guide pin monthly with white grease.

7.Lubricate the feed arm shaft and rack with light oil, a FEW drops weekly.

8.The Teflon® composition covers on the electrode and base plate must be changed as frequency of use dictates. They provide a non-stick surface, which can be wiped clean with a cloth.

9.Check the vacuum filters monthly and clean or replace as required.

Users Manual Electro-Sealer 7112 HF

Regular Maintenance 13

Image 17
Contents Electro-Sealer 7112 HF This page left blank intentionally Contents Pneumatic Drawings Limited Warranty Warranty InformationService PartsRead ALL Instructions Carefully Safety InstructionsModel 7112 Hopper Feed Heat Sealer Unit Specification To Change Time Settings InstallationLCD General Description Auto SwitchBasic Sealing Leveling the Press Operation Setting the ControlsOperation Security Level Selection Password TableSeries Hopper Feed Regular MaintenanceSymptoms Probable Cause Corrective Action Trouble ShootingSymptoms Probable Cause Corrective Action Symptoms Probable Cause Corrective Action Sealing ProblemsElectrical Drawings TB-3 Electrical Schematic Part7112 HF Hand SW R/H Yellow Brown Black Blue Hand SW L/H TOP Platen Bottom Platen Heater 300 Watt Pneumatic Drawings 70205326 Pneumatic SchematicPage Assembly Drawings Front Panel Assembly Drawing and Cover Front Panel Parts List Frame and Cover Assembly Drawing Frame and Cover Parts List Main Cylinder & Cabinet Assembly Drawing Main Cylinder & Cabinet Parts List Main Cylinder / Platen Assembly Drawing Main Cylinder / Platen Parts List Swing Arm & Base Plate Assembly Drawing Swing Arm & Base Plate Parts List Manifold Assembly Drawing Manifold Parts List Vacuum & Regulator Assembly Drawing Vacuum & Regulator Parts List Hopper Feed Assembly Drawing Hopper Feed Parts List 11 12 8 Bracket, Hopper side rail, RH