Sonos PLAYBAR manual Remove the template from the wall Drill pilot holes

Page 24

22	Product Guide

3.Use an awl or other sharp object to punch 4 small holes through 4 of the marked locations on the template. (If additional reinforcement is desired, 2 spare screws and anchors are included in the wall mount kit.) Placement may vary but holes should be located toward the corners, away from center.

4.Remove the template from the wall.

5.Drill pilot holes.

Because the anchors and screws are designed to be self-starting, this step is optional. However pre-drilling will result in a more accurate installation. Refer to the table below for more information.

Wall Material	Pre Drill	Use Wall Anchors	Use Screws

Wood Stud	with 1/8” (3mm) bit	No	Yes

Drywall (no stud)	with 3/16” (4.5mm) bit	Yes	Yes
Hard wallboard or double board	with 3/16” (4.5mm) bit	Yes	Yes
Plaster	with 1/4” (6.5mm) bit	Yes	Yes
Concrete or Brick	with 1/8” (3mm) bit	Yes	Yes

6.Insert and secure the wall anchors (supplied in the wall mount kit).

•If you are drilling into wood stud, do not use the wall anchors.

•If you are drilling into Sheetrock, screw the wall anchors into the drywall with a Phillips head screwdriver until the head is flat against or slightly below the wall surface, being careful not to overtighten.

Image 24

Contents Sonos Playbar By Sonos, Inc. All rights reserved Sonos Playbartm What’s in the BoxWhat’s Required Television requirementsHome network requirements Your home network must meet the following requirementsBefore You Begin Status Indicator Light Playbar FrontPlaybar Back Digital Audio In OpticalSelecting a Location TabletopWall mounting Setting Up the Playbar Product Guide Add the Sonos component that’s connected to your router If you are adding to an existing Sonos systemIf you’d like additional assistance Playbar Settings Remote control setupUsing a handheld Sonos controller Select Room Settings from the Settings menuUsing the Sonos Controller for Mac or PC Select Manage -Settings PC or Sonos -Preferences MacClick Remote Control Setup Equalization EQTV dialog settings Select Advanced Audio TV Dialog SettingsRecalibrating the audio Select Advanced Audio Recalibrate AudioSelect TV Setup and Control TV Autoplay Additional TV sound optionsTV autoplay Speech EnhancementIR signal light Select TV Setup and Control Ungroup on AutoplaySelect TV Setup and Control IR Signal Light Ungroup on autoplaySelect TV Setup and Control IR Repeater IR repeaterWhite status light Select White Status LightChanging room names Adding a Sonos SUBSelect Room Name SUB settings Select Advanced Audio SUB SettingsPlacement Adjustment phase Select On or Off Removing a SUBSurround settings Surround SpeakersAdding surround speakers Removing surround speakers Select Remove Surround SpeakersPlaying Music Wall Mounting What you will needRemove the template from the wall Drill pilot holes Sonos Playbar Basic Troubleshooting Playbar not detected during setupIdentify an unused device key Customer SupportLock your remote control to the new volume commands Verify that the problem is solvedSee Remote control setup on page 10 for help with this step Program the unused device keyIf you are using a Logitech universal remote If you are using another universal remoteTurning Off Your Television’s Speakers Can’t turn off TV speakersIndicator Light Explanations Playbar Status Indicator State Additional InformationImportant Safety Information Cleaning & MaintenanceLocation Proper VentilationReference Links Http//support.directv.comSonos Playbar