Peavey Automix2 manual Important Safety Instructions

Page 31

IMPORTANT SAFETY INSTRUCTIONS

WARNING: When using electric products, basic cautions should always be followed, including the following:

1.Read these instructions.

2.Keep these instructions.

3.Heed all warnings.

4.Follow all instructions.

5.Do not use this apparatus near water. For example, near or in a bathtub, swimming pool, sink, wet basement, etc.

6.Clean only with a damp cloth.

7.Do not block any of the ventilation openings. Install in accordance with manufacturerÕs instructions. It should not be placed flat against a wall or placed in a built-in enclosure that will impede the flow of cooling air.

8.Do not install near any heat sources such as radiators, heat registers, stoves or other apparatus (including amplifiers) that produce heat.

9.Do not defeat the safety purpose of the polarized or grounding-type plug. A polarized plug has two blades with one wider than the other. A grounding type plug has two blades and a third grounding plug. The wide blade or third prong is provided for your safety. When the provided plug does not fit into your inlet, consult an electrician for replacement of the obsolete outlet. Never break off the grounding write for our free booklet ÒShock Hazard and GroundingÓ. Connect only to a power supply of the type marked on the unit adjacent to the power supply cord.

10.Protect the power cord from being walked on or pinched particularly at plugs, convenience receptacles, and the point they exit from the apparatus.

11.Only use attachments/accessories provided by the manufacturer.

12.Use only with a cart, stand, tripod,bracket, or table specified by the manufacturer, or sold with the apparatus. When a cart is used, use caution when moving the cart/apparatus combination to avoid injury from tip-over.

13.Unplug this apparatus during lightning storms or when unused for long periods of time.

14.Refer all servicing to qualified service personnel. Servicing is required when the apparatus has been damaged in any way, such as power- supply cord or plug is damaged, liquid has been spilled or objects have fallen into the apparatus, the apparatus has been exposed to rain or moisture, does not operate normally, or has been dropped..

15.If this product is to be mounted in an equipment rack, rear support should be provided.

16.Exposure to extremely high noise levels may cause a permanent hearing loss. Individuals vary considerably in susceptibility to noise induced hearing loss, but nearly everyone will lose some hearing if exposed to sufficiently intense noise for a sufficient time. The U.S. GovernmentÕs Occupational and Health Administration (OSHA) has specified the following permissible noise level exposures:

Duration Per Day In Hours

Sound Level dBA, Slow Response

8

90

6

92

4

95

3

97

2

100

1 1/2

102

1

105

1/2

110

1/4 or less

115

According to OSHA, any exposure in excess of the above permissible limits could result in some hearing loss. Ear plugs or protectors to the ear canals or over the ears must be worn when operating this amplification system in order to prevent a permanent hearing loss if exposure is in excess of the limits as set forth above. To ensure against potentially dangerous exposure to high sound pressure levels, it is recommended that all persons exposed to equipment capable of producing high sound pressure levels such as this amplification system be protected by hearing protectors while this unit is in operation.

SAVE THESE INSTRUCTIONS!

31

Image 31
Contents AUTOMIX2ª Page Master Level Theory of Operation Front Panel Front Panel FeaturesIntroduction Channel LevelInternal Panel Internal Panel Features Master Gain Trim Power LEDAUX Master Level Control Downward ExpanderBack Panel Features Main OUT Remote VolumeMute Status OutputLink Port Link SwitchPower Switch MutebusEIN General Specs Setting the Notch Filter AUTOMIXª Setting up the Automixª Wiring Inputs and OutputsInitial Control Settings Setting the Channel LevelAttaching the Security Panel Setting the Overall LevelInterruptores DIP Funciones DEL Panel InternoFunciones DEL Panel Frontal Nivel DE Canal Nivel MaestroRecorte DE Ganancia Corte DE BAJOS/PLANODESACTIVADO/+48 Control DE SE„AL DE Muestra AuxiliarControl DE Frecuencia DE Filtro DE Muesca Funciones DEL Panel PosteriorRecorte DE Ganancia Maestro Control DE Nivel DE Filtro DE MuescaSalidas Directas Entradas DE LêNEAENTRADA/SALIDA DE INSERCIîN Interruptor DE DERIVACIîN DE SE„ALSalida Auxiliar Volumen RemotoEstado DE Salida Salida PrincipalConmutador DE Enlace Niveau DU Canal DIP SwitchsPanneau Avant Controles DU Panneau Avant Controles DU Panneau InterneExpandeur GainGain Master Sorties Direct Niveau DU Notch FilterLED Dõalimentation Insert Commutateur BypassSortie AUX Controle DU Volume a DistanceEtat DE Sortie Sortie MainConnexion IEC Alimentation Port LinkSelecteur Link Interrupteur DõalimentationHauptpegelregler Master Level Interne Panel FeaturesEinleitung KanalpegelAUX Master Pegelregler AUX Send ReglerAKTIVIT€T DER AKTIVIT€TS-/CLIP-LED Priority NUR Channel 1 undGER€TER†CKSEITE MIKROFONEING€NGE MIC Inputs Notch Filter PegelreglerNotch Filter Frequenzregler NETZ/SPANNUNGS-LEDDIREKTAUSG€NGE Insert Bypass SchalterAnmerkung Jeder Kanal kann maximal 10 mA speisen Hauptausgang Main OUT Netzschalter Link SchalterNETZANSCHLU§BUCHSE Peavey Electronics Corporation Limited Warranty Important Safety Instructions 80304515