Peavey Automix2 manual Back Panel Features

24 23 22 18 19

17

15

16

25 20 21

14

BACK PANEL FEATURES

14.MIC INPUTS

For use with low impedance microphones or low level sources. This is a transformer balanced input with an impedance of 2,000½. Input sensitivity for nominal output is -56dBu to -19dBu.

LINE INPUTS

These allow line level inputs to be used. This is a transformer balanced input through a 30dB resistive pad. Input impedance is >20k½.

15.INSERT IN/OUT

This is a signal loop that allows an external device such as an EQ to be inserted into the signal path of individual channels (refer to diagram below).

	Insert In/Out
IN	OUT
+ - G	G - +
	CEQ 280a

16.INSERT BYPASS SWITCH

When no signal processor is being used or bypassing the signal processor is desired, this switch should be in the ÒinÓ position. If a signal processor is being used, then this switch should be in the ÒoutÓ position.

17.DIRECT OUTPUTS

Each channel has direct output terminals that can be used for recording or anytime the out- put of an individual channel is required. This signal is independent of ÒAutomixÓ gain manipu- lation. The nominal output level is 2.21dBu (1 Volt).

6