VXI SM7100, Microwave Matrix user manual Avoid Electric Shock

Page 7

www.vxitech.com

WARNINGS (CONT.)

Avoid Electric Shock	To avoid electric shock or fire hazard, do not operate this product
	with the covers removed. Do not connect or disconnect any cable,
	probes, test leads, etc. while they are connected to a voltage source.
	Remove all power and unplug unit before performing any service.
	Service should only be performed by qualified personnel.
Ground the Product	This product is grounded through the grounding conductor of the
	power cord. To avoid electric shock, the grounding conductor must
	be connected to earth ground.
Operating Conditions	To avoid injury, electric shock or fire hazard:
	-	Do not operate in wet or damp conditions.
	-	Do not operate in an explosive atmosphere.
	-	Operate or store only in specified temperature range.
	-	Provide proper clearance for product ventilation to prevent
		overheating.
	-	DO NOT operate if you suspect there is any damage to this
		product. Product should be inspected or serviced only by
Improper Use		qualified personnel.
Improper Use	The operator of this instrument is advised that if the equipment is
	used in a manner not specified in this manual, the protection

provided by the equipment may be impaired. Conformity is checked by inspection.

SM7100 Preface

7

Image 7

Contents SM7100 VXI Technology, Inc Table of Contents Restricted Rights Legend WarrantyLimitation of Warranty CertificationEMC C L a R a T I O N O F C O N F O R M I T YTerms and Symbols General Safety InstructionsAvoid Electric Shock Support Resources Programming OverviewVswr SM7100 SpecificationsSMA Setting the Chassis Backplane Jumpers Calculating System Power and Cooling RequirementsIntroduction MSB LSB Setting the Logical AddressSelecting the Extended Memory Space VXI Technology, Inc SM7100 Preparation for Use Front Panel Connection SM7000 Switch ConfigurationGND EXTReturn GND SM7100 Module Configuration SM7100 Matrix Schematic Offset Hex VXI Technology, Inc SM7100 Module Configuration Addressing Register AccessOffset Write Function Smip II Register MAP A16Status Register 0x04 Read Only ID Register 0x00 Read OnlyLogical Address Register 0x00 Write Only Device Type Register 0x02 Read OnlyVersion Number Register 0x0E Read Only Offset Register 0x06 Read and WriteReserved Register 0x0A Read Only Reserved Register 0x0C Read OnlySubclass Register 0x1E Read Only NVM Access Resister 0x20 Read OnlyNVM Access Resister 0x20 Write Only Interrupt Control Register 0x1C Read and WriteTrace RAM End Low Register 0x2E Read and Write Trace RAM Start High Register 0x28 Read and WriteTrace RAM Start Low Register 0x2A Read and Write Trace RAM End High Register 0x2C Read and WriteTTL Trigger Polarity Register 0x38 -Write Only Loop EnableTrace Enable Open Trigger Select Register 0x36 -Write OnlyReserved Registers Read and Write Busy Trigger Control Register 0x3C Read and WriteTrigger Advance Register 0x3E Write Only Board Busy Register 0x3E Read OnlyAcfailn AddrBBM/MBB Control Register Read and Write Delay Register Read and Write Writing to the Relays Relay Register OffsetVIA16SPACE Index SM7100