Kenmore 7250, 7271, 7280 Aluminum foil and utensils, Replacing oven light some models, Glass, Wire

Page 25

Care & Cleaning

General cleaning

Refer to the Cleaning recommendation table in the Care & Cleaning section for more detailed information about cleaning specific parts of the range.

Before manually cleaning any part of the range, be sure all controls are turned OFF and the range is COOL. The range may be hot and can cause burns.

Ammonia must be rinsed before operating the oven. Provide adequate ventilation.

Aluminum foil and utensils

NEVER cover any slots, holes or passages in the oven bottom or cover an entire oven rack with materials such as aluminum foil. Doing so blocks air flow through the oven and may cause CARBON MONOXIDE poisoning.

Aluminum foil linings may trap heat, causing a fire hazard.

•Aluminum foil - Use of aluminum foil on a hot cooktop can damage the cooktop. Do not use thin aluminum cooking utensils or allow aluminum foil to touch the surface burners under ANY circumstances.

•Aluminum utensils - The melting point of aluminum is much lower than that of other metals. Care must be taken when aluminum pots or pans are used on the cooktop. If aluminum pans are allowed to boil dry when using the cooktop, the utensil may be damaged or destroyed.

Replacing oven light (some models)

Be sure the range is unplugged and all parts are COOL before replacing oven light. Wear a leather- faced glove for protection against possible broken glass.

The oven light is located at the rear of the oven cavity and is covered with a glass shield held by a wire holder. The glass shield protects the light bulb and must be in place whenever the oven is in use.

glass

shield

wire

holder

To replace the interior oven light bulb:

1.Turn electrical power off at the main source or unplug the range.

2.Press wire holder to one side to release the glass shield that covers the light bulb.

3.Replace light with a new 40 watt appliance bulb.

4.Replace glass shield over bulb and snap wire holder back into place.

5.Turn power on at the main source (or plug the appliance in).

6.The clock will then need to be reset. To reset, see Setting clock in this Use & Care Guide.

25

Page 24 Page 26
Image 25
Page 24 Page 26
Contents Use & Care Guide Guía de uso y cuidada KenmoreKenmore Limited Warranty Table of ContentsTip Over Hazard Read all instructions before using this applianceSave these instructions for future reference Important Instructions for Using Your Oven Important safety notice Important Instructions for Using Your CooktopSerial Plate Location Product RecordGrounding Instructions Conversion to L.P. GasOven vent location Before Setting Oven ControlsTypes of oven racks Air circulation in the ovenInstalling burner grates Before Setting Surface ControlsRemember Burner headSetting proper burner flame size Using proper cookwareCookware material types Flame size Type of cookingSetting surface burners Setting Surface ControlsHome canning Setting Clock Setting Oven ControlsSetting silent or audible control mode Oven Control FunctionsSetting Timer Changing temperature display F or COven Lockout Setting BakeWhen the cook time runs out Setting Cook TimeUntil is pressed Operating oven light Setting Delay StartHow convection works Benefits of convection cookingTo set Convection on some models BakingBroil Suggested broil settings table gas ovenTo set Broil To add Warm & Hold when baking with Cook Time Adjusting Oven TemperatureTo adjust oven temperature Warm & HoldWarmer drawer recommended food settings Food Item Setting Warmer drawer recommended settingsStorage in or on appliance-flammable Setting warmer drawer Warmer drawer indicator lightFlex Clean can not be set when the warmer drawer is active To set warmer drawerRead before starting Select Clean Select CleanSetting Select Clean To set Select Clean to start immediatelyWhen Select Clean is finished Delayed Start Select CleanTo start a Delay Start Select Clean Cleaning recommendation table Care & CleaningCleaning surface burner grates Cleaning recessed and contoured areas of cooktopCleaning burner caps Cleaning surface burner headsAluminum foil and utensils WireReplacing oven light some models GlassSpecial door care instructions Removing and replacing the lift-off oven doorTo remove oven door To replace oven doorProblem Solution Running Select Clean cycle Be sure oven door closed when broilingSection SearingCooktop and surface burners in the Care & Cleaning section Surface burners in the Care & Cleaning sectionUnavoidable due to salt content in air Surface burners do not igniteProtection Agreements Acuerodes de protección
Top Page Image Contents