Kenmore 7271 Before Setting Surface Controls, Installing burner grates, Remember, Burner head

Page 8

Before Setting Surface Controls

Check burner cap placement before operating the surface burners

To prevent flare-ups and avoid creation of harmful by-products, do not use the cooktop without all burner caps properly installed to insure proper ignition and gas flame size.

It is very important to be sure that all surface burner caps and burner grates are properly installed and in the correct locations BEFORE operating the cooktop burners.

Remember:

Always keep surface burner caps in place whenever using a surface burner.

When placing the burner caps, be sure that all burner caps are seated firmly and rest level on top of burner heads.

For proper flow of gas and ignition of burners DO NOT allow spills, food, cleaning agents or any other material to enter the gas orifice port opening.

On round style burners, the burner cap lip (See Fig. 1) should fit snug into the center of burner head and rest level. Refer to Figs. 2 & 3 for correct and incorrect burner cap placement. Once in place, you may check the fit by gently sliding the burner cap from side to side (Fig. 4) to be sure it is centered and firmly seated. When the burner cap lip makes contact inside the center of the burner head you will be able to hear the burner cap click. Please note that the burner cap should NOT move off the center of the burner head when sliding from side to side.

Check and be sure that all oval style (some models) burner caps are correctly in place on oval burner heads.

Installing burner grates

Do not use the surface burners without the burner caps and burner grates properly installed. Missing pieces or improper installation may lead to spills, burns, or damage to your range and cookware.

Make sure the burner grates are properly placed on the cooktop before using the surface burners. The grates are designed to rest inside the recess on the cooktop.

To install burner grates, place grates flat-side down and align into the cooktop recess. Grates should rest flush against each other and against the sides of the recess (See Fig. 5).

Burner cap

Burner cap lip

Burner head

Fig. 1

Correct burner cap

 

Incorrect burner cap

placement

 

 

 

placement

Fig. 2

 

 

 

Fig. 3

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

Fig. 4

Fig. 5

8

Image 8
Contents Kenmore Use & Care Guide Guía de uso y cuidadaTable of Contents Kenmore Limited WarrantySave these instructions for future reference Read all instructions before using this applianceTip Over Hazard Important Instructions for Using Your Oven Important Instructions for Using Your Cooktop Important safety noticeProduct Record Serial Plate LocationGrounding Instructions Conversion to L.P. GasBefore Setting Oven Controls Oven vent locationTypes of oven racks Air circulation in the ovenBefore Setting Surface Controls Installing burner gratesRemember Burner headUsing proper cookware Setting proper burner flame sizeCookware material types Flame size Type of cookingHome canning Setting Surface ControlsSetting surface burners Setting Oven Controls Setting ClockSetting silent or audible control mode Oven Control FunctionsChanging temperature display F or C Setting TimerSetting Bake Oven LockoutUntil is pressed Setting Cook TimeWhen the cook time runs out Setting Delay Start Operating oven lightBenefits of convection cooking How convection worksTo set Convection on some models BakingTo set Broil Suggested broil settings table gas ovenBroil Adjusting Oven Temperature To add Warm & Hold when baking with Cook TimeTo adjust oven temperature Warm & HoldStorage in or on appliance-flammable Warmer drawer recommended settingsWarmer drawer recommended food settings Food Item Setting Warmer drawer indicator light Setting warmer drawerFlex Clean can not be set when the warmer drawer is active To set warmer drawerSelect Clean Read before starting Select CleanSetting Select Clean To set Select Clean to start immediatelyTo start a Delay Start Select Clean Delayed Start Select CleanWhen Select Clean is finished Care & Cleaning Cleaning recommendation tableCleaning recessed and contoured areas of cooktop Cleaning surface burner gratesCleaning burner caps Cleaning surface burner headsWire Aluminum foil and utensilsReplacing oven light some models GlassRemoving and replacing the lift-off oven door Special door care instructionsTo remove oven door To replace oven doorProblem Solution Be sure oven door closed when broiling Running Select Clean cycleSection SearingSurface burners in the Care & Cleaning section Cooktop and surface burners in the Care & Cleaning sectionUnavoidable due to salt content in air Surface burners do not igniteProtection Agreements Acuerodes de protección