Kenmore 790.9911 manual Care and Cleaning of Stainless Steel some models, To Remove Oven Door

Page 35

General

Care & Cleaning

 

 

@

FEATURE

OVERVIEW

 

 

 

Cleaning Recommendations for Ceramic Glass Cooktops (cont'd.)

Care & Cleaning of Stainless Steel / Removing

& Replacing Oven Door

DO not use

the following

on the

ceramic

glass cooktop:

Do not use abrasive cleaners and scouring pads, such as metal and some

nylon pads. They may scratch the

cooktop, making it more difficult to clean.

Do not use harsh cleaners, such as chlorine bleach, ammonia or oven

cleaners, as they may etch or discolor the cooktop.

Do not use dirty sponges, cloths or paper towels, as they can leave soil or

lint on the cooktop which can burn and later cause discoloration.

Special Caution for Aluminum Foil and Aluminum cooking utensils:

•Aluminum Foil - Use of aluminum foil will damage the ceramic cooktop. Do not use thin aluminum cooking utensils or allow aluminum foil to touch the ceramic cooktop under ANY circumstances.

•Aluminum utensils - The melting point of aluminum is much lower than that of other metals. Care must be taken when aluminum pots or pans are used on the cooktop. If allowed to boil dry, not only will the utensil be destroyed, but it may fuse to, break or mark the ceramic glass surface, permanently damaging the cooktop surface.

Care and Cleaning of Stainless Steel (some models)

Some models are equipped with Stainless Steel exterior parts. Special care and cleaning are required for maintaining the appearance of Stainless Steel parts. Please refer to the Care & Cleaning Table provided at the beginning of the Care & Cleaning section in this Use & Care Guide.

Removing and Replacing the Oven Door

The door is heavy. For safe, temporary storage, lay the door flat with the inside of the door facing down.

To Remove Oven Door:

1.Open oven door completely (horizontal with floor - See Fig. 1).

2.Remove 2 screws located on the inside of the door liner (See A Fig. 2)

3.Insert the 2 screws into the door hinge holes located on the side of the hinge arm, one into each hinge (See B Fig. 2).

4.Close oven door until the door stops, (Do not force the door to close any further). The placement of these screws should keep door open in about a 45 degree position.

5.Grasp oven door firmly on both sides and slide door up and off hinges at the same angle. (See Fig. 3)

6.To clean oven door follow the instructions in the Care & Cleaning Table.

or

usa

Fig. 2

about 45

To Replace Oven Door:

1.Be sure the hinge arms remain at the 45 degree angle position. Be sure the screws are still locking the hinge arms from moving. If the screws fall out of the hinge holes, the hinge(s) may snap back against the oven frame and could pinch fingers or chip the porcelain finish on the oven front frame.

2.Hold door at the sides near the top while resting the lower front of door on your knee. Insert the door channels at the bottom of door over the door hinges, (See Fig. 3).

3.Allow the door to slide down into the door hinges evenly at the same 45 degree angle. The hinge arms should be inserted into the bottom corners as far as they can go.

4.Open door completely (horizontal with floor) and remove both screws from holes in door hinges.

5.Reinstall the 2 screws into the door liner (See C Fig. 2).

6.If the door is not in alignment with the oven frame, remove door and repeat the above steps.

Hinge

Fig. 3

35

Page 34 Page 36
Image 35
Page 34 Page 36
Contents Electric Ran e Contents Tip bracket installation Important Safety InstructionsImportant Instructions for Cleaning Your Range Important Instructions for Using Your CooktopImportant Instructions for Using Your Oven Self Cleaning OvensCanada Master Protection Agreements8OOW6 About the Radiant Surface Elements Setting Surface ControlsFeature Overview About the Ceramic Glass CooktopElectronic Surface Element Control Esec Available Esec Window Display SettingsEsec Lockout Feature Feature OverviewTo Operate the Single Radiant Surface Elements Recommended Surface Cooking SettingsOperating Single Radiant Surface Elements Right Operating the Triple Surface ElementTo Operate the Triple Surface Element SizeLeft Side HOT Surface Operating the Bridge Surface ElementTo Operate the Bridge Surface Element ALL +BRIDGE oTo Set the Warmer Zone Control Warmer Zone Temperature SelectionCooking Operating the Warmer Warm & Ready TM ZoneOperating the Warmer Drawer Surface CookingArranging Warmer Warm & Ready TM Drawer Rack Positions MED Warmer Drawer Food Temperature SettingsTo Set the Warmer Drawer & Bread Proofing Controls Preparing Bread Dough for the Warmer DrawerArranging Oven Racks Before Setting Oven ControlsAir Circulation in the Oven MIN. TEMP./TIME Electronic Oven Control Pad FeaturesPad Settings Minimum and Maximum ControlPressdisplay Setting the ClockInstructions Instructions Press Display Setting Kitchen TimerEnergy Saving Setting Temperature Display --Fahrenheit or Celsius Consumer Defined Control FeaturesSetting Oven Lockout Feature To activate the Oven Lockout featureConsumer Defined Control FeaturesPreheat Setting Oven ControlsSetting Preheat To set the Preheat temperature for 350FBake Setting BakeTo set the Bake Temperature to 350F Press Display Setting Timed BakeInstructionspress Setting Oven Controls Setting Delayed Time BakeEnter the desired baking time using the number pads by When the set bake time runs outBroiling Times and Searing Grill Setting BroilSet the oven to broil at the default setting 550F Category Setting the Food Categories FeaturesRecommended Foods to be Cooked in eachBenefits of Convection Bake Setting Convection BakeTo set the oven for Convection Bake Temperature to 350F Serve Warm To set Serve Warm to turn on automaticallyOven Cleaning Instructions Press Display Stopping or Interrupting a Self-Cleaning cycleIcon To Start the Delayed Self-Clean CycleStart Time Adjust Oven temperature Lower Adjusting Oven TemperatureTo adjust the oven temperature higher Stainless Steel, chrome General Care & CleaningGlass control panel For heavy, burned on soil Cleaning Recommendations for the Ceramic Glass CooktopPlastic or foods with a high sugar content For light to moderate soilTo Remove Oven Door Care and Cleaning of Stainless Steel some modelsTo Replace the Oven Lights Oven LightsTo Remove and Replace Warmer Warm & Ready TM Drawer To Operate the Oven LightsSolutions to Common Problems Possible CAUSE/SOLUTIONOccurrence Decrease Normal cook time by Meats 15-30 % Poultry unstuffed 20-30 %Foods for Convection Bake pad *Decrease Normal cook time by Foods for Meats padCall anytime, day or night U.S.A. and Canada Au Canada pour service en franaisCanadal

790.9911 specifications

The Kenmore 790.9911 is a versatile and reliable gas range that combines modern technology with practical design to elevate your cooking experience. With its sleek stainless steel finish, it not only complements any kitchen décor but also offers durability for daily use.

One of the main features of the Kenmore 790.9911 is its powerful cooking capacity. The range is equipped with five sealed burners, including a robust 17,000 BTU burner for high-heat searing, making it ideal for a range of cooking techniques. The additional burners each provide varying levels of heat output, allowing for optimal control when preparing everything from delicate sauces to hearty meals. The burners are designed for easy cleanup, preventing spills from reaching the internal components.

A significant technological advancement in the Kenmore 790.9911 is its electronic ignition system, which provides reliable and energy-efficient ignition. This feature eliminates the need for standing pilot lights, ensuring safety and enhanced efficiency. The oven features a convection baking option, distributing heat evenly throughout the oven space for perfect results. Convection fans circulate hot air, allowing dishes to cook faster and more evenly.

The oven capacity is another standout characteristic, with an impressive 5.6 cubic feet of space, making it suitable for cooking multiple dishes at once. The oven has several cooking modes, including bake, broil, and self-clean, simplifying the cooking process and post-cooking cleanup. The self-clean feature enhances convenience, allowing for easy maintenance of the oven's interior.

A modern digital display panel provides intuitive control over cooking settings. It features a timer and temperature settings, enabling precise cooking and baking without guesswork. With added functionality like a delay bake setting, users can schedule their cooking time to match their busy lifestyles.

Safety is not overlooked in the Kenmore 790.9911, as it includes features like burner caps that reduce the risk of flare-ups and an oven door that remains cool to the touch while in use, minimizing potential hazards.

With its combination of power, efficiency, and user-friendly features, the Kenmore 790.9911 is an ideal choice for both novice cooks and seasoned chefs looking to enhance their culinary adventures. Whether you're roasting, baking, or simmering, this gas range delivers performance and reliability expected from a premium kitchen appliance.
Top Page Image Contents