General Care & Cleaning
Hinge
e lever hook
Removing and Replacing the Oven Door
suppor
Lock engaged for door removal Figure 1
HINGE SLOT =Door removed
from the oven
Figure 2
Hinge lever
The door is heavy. For safe, temporary storage, lay the door flat
with the inside of the door facing down.
To Remove Oven Door:
1.Open the door to the fully opened position.
2.Pull up the lock located on both hinge supports and engage it in the hinge lever hooks (Figure 1). You may have to apply a little downward pressure on the door to pull the locks fully over the hinge lever hooks.
3.Grab the door by the sides and pull the bottom of the door up and toward you to disengage the hinge supports. Keep pulling the bottom of the door toward you while rotating the top of the door toward the range to completely disengage the hinge levers (Figure 2).
4.To clean oven door, follow the instructions provided in the General Care & Cleaning table.
To Replace Oven Door:
1. Grab the door by the sides; place the hinge supports in the hinge slots. Open
the door to the fully opened position.
2. Disengage the lock from the hinge lever hooks on both sides (Figure 3). '
Note: Make sure the hinge supports are fully engaged before unlocking the
hinge | levers. | ........ |
3. Close | the oven door. | ii |
:,: | ||
Special | Door Care | Instructions |
Most oven doors contain glass that can break.
Read the following recommendations:
1.Do not close the oven door until all the oven racks are fully in place.
2.Do not hit the glass with pots, pans, or any other object.
3.Scratching, hitting, jarring or stressing the glass may weaken its structure causing an increased risk of breakage at a later time.
Lock in normal position Figure 3
Care and Cleaning of Stainless Steel (somemodels)
Some models are equipped with stainless steel exterior parts. Special care and cleaning are required for maintaining the appearance of stainless steel parts.
Please refer to the table provided at beginning of the Care & Cleaning section in this Use & Care Manual.
Changing the Oven Light
On some models an interior oven light will turn automatically when the oven door is opened. The oven light may be turned on when the door is closed by
/ pushing the knob located on the control panel. On some models, the lamp is covered with a glass shield held in place by a wire holder. THE GLASS SHIELD MUST BE IN PLACE WHENEVER THE OVEN IS IN USE.
To replace the light bulb:
CAUTION: BE SURE THE OVEN IS COOL.
1.Turn the power off at the main source.
2.Wear a
3.Replace bulb with
4.For models with glass shield, press holder on one side to release glass shield, change bulb and be sure to replace the glass shield.
17