Kenmore 795.775736, 795.775796, 795.775636 manual Troubleshooting, Error Code Summary, Category

6. TROUBLESHOOTING

6-1. Error Code Summary

wWARNING : When you check the Resistance values, be sure to turn off the power. And wait for the voltage-discharge sufficiently.

		Error Display
	Error Detection			Error Generation Factors	Remark
NO		Freezer	Ref.
	Category
		Temperature	Temperature
1	Normality			None	Normal operation of Display
2	Freezer Sensor	Er	FS	Short or Disconnection
	Error			of Freezer Sensor
3	Refrigerator	Er	rS	Short or Disconnection
	Sensor Error			of Refrigerator Sensor	Check each sensor and its
					connector.
4	Defrosting	Er	dS	Short or Disconnection
	Sensor Error			of Defrosting Sensor
5	Icing Sensor	Er	IS	Short or Disconnection
				of Icing Sensor
	Error
				Even though it is passed
				1 hour since then	Temperature Fuse
6	Poor Defrosting	Er	dH	Defrosting , if Defrosting	Disconnection, Heater
				sensor is not over 8°C, it	disconnection, DRAIN Jam,
				is caused	Poor Relay for Heater
				It is caused when	Poor BLDC Motor
	Abnormality of			feedback signal isn’ t	connection, DRIVE IC, and
7	BLDC FAN Motor	Er	IF	over 115	TR Tx/Rx between icemaker
	for Ice Making			seconds during BLDC	and main board.
				FAN motor operating
				It is caused when	Poor BLDC Motor
	Abnormality of			feedback
					connection, DRIVE IC, and
8				signal isn’ t over 115
	BLDC FAN Motor	Er	FF		TR Tx/Rx between icemaker
				seconds during BLDC
	for Freezer				and main board.
				FAN motor operating
	Abnormality of			It is caused when	Poor BLDC Motor
9				feedback	connection, DRIVE IC, and
	BLDC FAN Motor	Er	CF	signal isn ’ t over 115	TR Tx/Rx between icemaker
	for Mechanic Room			seconds during BLDC	and main board.
				FAN motor operating
				Communication Error	Poor Communication
	Communication				connection,Poor TR of
10		Er	CO	between Micom of Main	Transmitter and Receiver
	Error
				PCB and Display Micom	Tx/Rx between icemaker
					and main board.

- 17 -