8-21. WATER VALVE DISASSEMBLY METHOD
1)Turn off the water. Then separate the water line from the valve.
2). Separate the mechanical cover and valve screw.
Mechanical Cover
3)Separate the housing and pull out the valve.
Housing
4)Lay a dry towel on the floor and get ready to spill water from the water filter. Pull out the cilp. Then press te the collet to separate the tube from the connector and pour out the water until emptied.
8-22. FAN AND FAN MOTOR DISASSEMBLY METHOD
1)Using a short screwdriver, loosen one SCREW in DRAIN PIPE ASSEMBLY and one connected to the
MOTOR COVER.
MOTOR COVER
→
2)Pull and separate the FAN ASSEMBLY and MOTOR turning counterclockwise based on the MOTOR SHAFT.
FAN ASSEMBLY | MOTOR |
→
Reassembly is in the reverse order of the disassembly and take special care for the following details.
1.Be careful not to bend the tube during assembly.
2.Press the WATER DISPENSER button until water pours out and check for leakage in the CONNECTOR TUBE (It differs by the water pressure but usually takes about 2 minutes for the wayer to drain.)
- 63 -