Kenmore 596.52673200 Dispenser Operation, Dispenser Lock, Filter Status Indicator Light, Mode

fiYPBUTTOH(OHTROLFEATURES

0 0 o o c) o

OCHANGE

<=>GOOD

FILTER DISPENSER FILTERED ICE & WATER LIGHT

II'1

SENSOR

LIGHT

B

DISPENSER

OPERATION

Todispense:

>SelectCUBE, CRUSH or WATER mode by pushing buttonon dispenser

control panel. A green indicator light above button shows mode selection.

Presscontainer againstdispenser pad. Selection mode may not be changed while ice dispenser is in operation,

NOTE: If waterdispenser is continuouslyactive for more than 5 minutes,an automatic lock out sensor willshut down power to dispenser area. Forinstructions on how to unlock your dispenser,see the section entitled DispenserLock below.

DISPENSER LOCK

Thisfeature preventsice or

water from being dispensed.

To lock and unlock dispenser:

>To lock dispenser, press and hold LOCK/UNLOCK button for 3

seconds. A green indicator light above button confirms dispenser is locked.

>To unlock dispenser, hold LOCK/UNLOCK button for 3

seconds. Green indicator light above button will go out.

FILTER STATUS	o
INDICATOR LIGHT	o°ooo
	€_ CHANGE
The filter status indicator light
serves as a reminder to	FILTER

replace the water filter. A green light indicates that the filter is in good condition. A red light indicates the filter

should be changed. Once light turns red, it will remain red until function is reset.

To reset indicator:

>Press and hold both LOCK/UNLOCK

and WATER buttons simultaneously for 4 seconds. The green filter status indicator light will flash 3 times when the function has successfully reset.

AUTO LIGHT

The auto light function

offers the ability to activate the dispenser light at half-power when the

LIGHT SENSOR detects that the light levels in room are low.

To activate and deactivate auto light:

To activate, press ON/OFF button located on control panel. A green

indicator light above button displays to show that sensor is active.

>- To deactivate, press ON/OFF button. Green indicator light will go out.

NOTE: Dispenser light will operate whether or not auto light is selected.

SABBATH_+_

MODE

This mode is intended to deactivate power to the LED and dispenser lights, while allowing the controls to remain operational.

To activate and deactivate Sabbath Mode:

To activate, press and hold both LOCK/UNLOCK and ON/OFF buttons simultaneously for 3 to 4 seconds. After 3 to 4 seconds, the LED and dispenser lights will turn off. Dispenser light will not activate

during dispensing while in this mode.

To deactivate, press and hold both LOCK/UNLOCK and ON/OFF buttons simultaneously for 3 to 4 seconds. After 3 to 4 seconds, the LED and dispenser lights will activate.

NOTE: In the event that power is interrupted while the Sabbath Mode is active, the control will remain in Sabbath Mode when power returns.

]9