Kenmore 596.50014100, 596.53463300 Light Function, Filter Status, Indicator, Temperature Keys

DISPENSERf[ATIJRt(oNtS,.

[i[(TRONi((OHTROL[[ATUR[$

		OFF
		ON
	DISPENSER	LIGHT
GOOD
DHANGEO	_	SENSOR
FILTER

DISPENSER

OPERATION

To dispense water:

>Selectthe WATER button. _j

>Press container against dispenser pad.

To dispense ice:

>Select the CUBE button for cubedice.

> Pressthe CRUSH button for _] crushedice.

>Press container against dispenser pad.

NOTE: If water dispenser is continuously active for more than 2 minutes, an automatic lock out sensor will shut down power to dispenser area. For instructions on how to unlock your dispenser, see the section entitled Dispenser Lock below.

DISPENSER LOCK

Thisfeature prevents ice or waterfrom being dispensed.

To lock and unlock dispenser:

To lock dispenser, press and hold the LOCK/UNLOCK button for 3

seconds. A green indicator light

above button confirms dispenser is locked.

To unlock dispenser, hold the

LOCK/UNLOCK button for 3

seconds. Green indicator light above button will go out.

LIGHT FUNCTION

The lightfunction offerstwo settings:OFF and AUTO.

The OFF setting will turn off the dispenser cavity light.

The AUTO setting allows the SENSOR to measure the surrounding light levels and adjust the power of the cavity light accordingly. When the sensor registers lower light levels (night time, darkened kitchen), the cavity light will respond at 50% power. When the sensor registers high light levels (lighted kitchen, direct sunlight), the cavity light will not activate.

NOTE: Dispenser light will operate at

full power when ice or water functions are in use.

To activate auto setting:

Press the ON/OFF button located on control panel. When the green indicator light above the button display is on, the cavity dispenser light will use the AUTO setting.

To deactivate auto setting:

Press the ON/OFF button located on control panel. Green indicator light above button will go out.

FILTER STATUS	FILTER
INDICATOR	GOOD
	c.,.G o
LIGHT

The filter status indicator light serves as

areminder to replace the water filter. A green light indicates that the filter is in good condition. A red light indicatesthe filter should be changed. Once light turns red, it will remain

red until function is	@ 4- [_
reset.

To reset indicator:

>Press and hold both the LOCK/ UNLOCK and the WATER buttons simultaneously for 4 seconds. The green filter status indicator light will flash 3 times when the function /,,

has successfully reset,	_Mps_
	v

TEMPERATURE KEYS

These keys will lower or raise the freezer or fresh food compartment temperature.

NOTE: See the section How to Adjust

the Temperature Controls (page 12) for instructions on how to set food

compartment temperatures.

10