Kenmore 596.534623, 596.53463300, 596.52679200, 596.52672200, 596.53464300 manual Ieandwater, @Nt

@NT,

PROBLEM

Temperature-controlled drawer and/or crisper drawer do not close freely

Refrigerator runs too frequently

POSSIBLE CAUSE

Contents of drawer, or positioning of items in the surrounding compartment could be obstructing drawer

Drawer is not in proper position Refrigerator is not level.

Drawer channels are dirty or need treatment. Doorshave been opened frequently or have been opened for long periodsof time.

Humidity or heat in surrounding area is high. Food has recently been added.

Refrigerator is exposed to heat by environment or by appliances nearby. Condenser coils are dirty.

Controls need to be adjusted.

Door is not closing properly

Door gaskets are not sealing properly.

SOLUTION

See drawersectionin Refrigerator Features to properly install drawers.

See leveling instructions in Installing Your Refrigerator. Apply a thin layer of petroleum jelly to drawer channels. Reduce time door is open. Organize food items efficiently to assure door is open for as short a time as possible.

Allow interior environment to adjust for period the door has been open.

Normal operation.

Allow time for recently-added food to reach refrigerator or freezer temperature.

Evaluate your refrigerator'senvironment. See locationm selection section in Installing Your Refrigerator.

Clean according to cleaning instructions in Hints and Care. See temperature controls section in Installing Your Refrigerator to adjust your controls.

See leveling instructions in Installing Your Refrigerator, Check for internal obstructions that are keeping door from closing properly (i.e. improperly closed drawers, ice buckets, oversized or improperly stored containers or foodstuffs, etc.). Clean according to cleaning instructions in Hints and Care.

I(EANDWATER

Water appears cloudy

Particles in water and/or ice cubes.

No indicator lights

are lit on dispenser control

Neither ice nor water is dispensed when pads are

pushed

Ice maker is not producing enough ice or ice is malformed

Air or air bubbles in water.

Carbon dust from water filter cartridge.

Concentrationsof mineralsin water willform particleswhenwater becomesfrozen and melts. Freezer door is not closed.

Refrigerator is not plugged in.

Fuse is blown, or circuit breaker needs to be reset.

Power outage has occurred.

Refrigerator is in Sabbath Mode.

Freezer door is not closed.

Controls are in lock mode.

Water tank is filling.

Ice maker or ice maker-equipped refrigerator has just recently been installed or a large amount of ice has just been used.

Water filter is clogged or needs to be changed.

Ice maker has just recently been installed or a large amount of ice has just been used. Water pressure is too low.

Water filter is clogged or needs to be changed.

This is normal when first using dispenser and will disappear with use.

Initial water ejected through cartridge may contain harmless carbon dust flushed from cartridge. Particles are safe for consumption. Will disappear after the first few uses. Particles are not harmful and naturally occur in water supplies.

Verify that freezer door is closed. Power is removed from the control when freezer door is opened.

Plug in refrigerator.

Replace any blown fuses. Check circuit breakers for any tripped circuits.

Call local power company listing to report outage.

See Dispenser Features section for further information. Verify that freezer door is closed. Power is removed from the control when freezer door is opened.

See control instructions in Dispenser Features.

At initial use, there is an approximate 45-second delay in dispensing while the internal water tank is filling.

Wait 24 hours for ice production to begin and for ice maker to restock after emptied.

Change water filter.

Wait 24 hours for ice production to begin and for ice maker to restock after emptied.

Low water pressure can cause valve to leak. Water pressure must be between 20 to 100 pounds per square inch to function

properly. A minimum pressure of 35 pounds per square inch is recommended for refrigerators with water filters.

Change water filter.

2t