Kenmore 596.50002100, 596.53463300, 596.52679200, 596.52672200 manual @Nt, Dispenserwateris not cold

AND @NT.

Ice maker is not

_roducing ice

Water filter indicator light is red

Refrigerator is leaking water

Ice maker arm is not in correct position.

Household water supply is not reaching water valve

Copper or plastic tubing has kinks.

Water pressure is too low.

Check freezer temperature.

Ice bin is not installed properly Improper water valve was installed.

Water filter needs to be replaced.

Filter indicator sensor needs to be reset.

Plastic tubing was used to complete water connection.

Confirm ice maker arm is down. See Freezer Features section in your owner'smanual for details

Check water connection procedure written in Installing Your

Refrigerator.

Turn off water supply and remove kinks. If kinks cannot be removed, replace tubing.

Water pressuremust be between20 to 100 pounds per square inch to function properly.A minimumpressure of 35 pounds per square inch is recommendedfor refrigeratorswith water filters. See temperature controls section in Installing Your Refrigerator to adjust your controls. Freezer must be between 0 to 2° F (-18 to -17 ° C) to produce ice.

See ice bin section for proper installation and alignment. Check water connection procedure in your Installation Instructions. Self-piercing and %" saddle valves cause low

water pressure and may clog the line over time. The manufacturer is not responsible for property damage due to improper installation or water connection.

If filter is not available, replace with bypass filter. See Dispenser Features section for directions.

See Dispenser Features section for directions.

The manufacturer recommends using copper tubing for installation. Plastic is less durable and can cause leakage.

The manufacturer is not responsible for property damage due to improper installation or water connection.

Improper water valve was installed

Ice forms in inlet tube	Water pressure is low.
to ice maker

Freezer temperature is too high.

Check water connectionprocedure in yourInstallation Instructions. Self-piercing and %" saddle valves cause low water pressure and may clog the line over time. The manufacturer is not responsible for property damage due to improper installation or water connection.

Water pressure must be between 20 to 100 pounds per square inch to function properly. A minimum pressure of 35

pounds per square inch is recommended for refrigerators with water filters.

See temperature controls section in Installing Your Refrigerator to adjust your controls. Freezer must be between 0 to 2° F (-18 to -17 ° C) to produce ice.

Waterflow isslower thannormal

Dispenserwateris not cold

Water pressure is too low.

Improper water valve was installed.

Copper or plastic tubing has kinks.

Water filter is clogged or needs to be changed.

Refrigerator has been recently installed. Water supply in holding tank has been depleted.

Water has settled into water lines outside holding tank and has warmed to room temperature.

Water pressure must be between 20 to 100 pounds per square inch to function properly. A minimum pressure of 35 pounds per square inch is recommendedfor refrigerators with water filters.

Check water connection procedure in your Installation Instructions. Self-piercing and _,6"saddle valves cause low water pressure and may clog the line over time. The manufacturer is not responsible for property damage due to improper installation or water connection.

Turn off water supply and remove kinks. If kinks cannot be removed, replace tubing.

Change water filter.

Allow approximately 12 hours for water in holding tank to chill.

Discardfirst glass of water and refill.

Z8