Toro TWRS manual Sensor Module Features

Page 11

Sensor Module Features

1– Rain Threshold Adjustment–Adjusts the rain sensor to accumulate 1/8", 1/4", 1/2" or 3/4" (3mm, 6mm,12mm or 19mm) of rainfall before signaling the receiver to hold watering. (Factory default setting 1/4" (6mm).

2– Sensor Test Spindle–Pressed to manually activate the sensor for setup and test procedures.

3– Batteries (not shown)–Two 3V lithium batteries, installed

at time of manufacture, will provide approximately five years of service under normal use conditions.

4– Antenna–Positioned downward for maximum signal transmission strength.

5– Pipe-mountAdapter–Replaces Quick Clip mounting bracket to enable installation on 1/2" (13mm) diameter Schedule 40 PVC pipe.

6– Quick ClipTM Mounting Bracket–Simplifies sensor module installation. Adjustable pivot point for easy vertical alignment.

1	2
6
	3
	4
	5
	9

Image 11

Contents User’s Guide Contents Page Here’s all there is to it Getting StartedStep Receiver Module Features Installing the Receiver Module Wiring Procedure I sensor-ready Connecting the Receiver WiresNormally-open Sensor Wiring Procedure II no sensor featureLeast of 15 seconds to establish communication Initial System TestSensor Module Features Installing the Sensor Module 1/4 Washer Freeze Sensor Site Selection Select Temperature Scale Set Temperature Activation Threshold Twrfs models onlySelect Temperature Threshold Page Water Delay Feature Smart Bypass FeatureRefer to Sensor Module Battery Replacement on Signal Strength DisplayBattery Strength Display Fail Safe Feature Dry Out FeatureLoss of communication Prolonged Active ModeTurn the Receiver Module Off and On Set or Restore the Sensor Address CodeUnscrew and remove the bottom cap from the sensor housing Sensor Module Battery ReplacementTo improve signal strength TroubleshootingSolving Reception Problems Sensor module does not activate the receiver at close range Receiver display is blankSpecifications Toro Promise Five-year Limited Warranty FCC ID OF7TWRS