Toro TWRS manual Dry Out Feature, Fail Safe Feature

Page 20
Figure 24

Dry Out Feature

The Dry Out feature is provided to override the Water Conservation baseline level, allowing the dry-out delay period to be set in 0.5-day increments from 0.5 to 4.0 days.

Note: Before using the Dry Out feature, allow the sensor system to normalize by cycling through rain and/or freeze activation several times.

1. Press the Setup button to display Dry Out. The display will indicate the current Dry Out day setting (factory default is 0.0).

2. Press the Adjust button to select the desired value (0.5 to 4.0 days). See Figure 24.

Note: Once activated, Dry Out operation can be canceled by pressing the Smart Bypass button.

Note: Reselecting a Water Conservation level will override the Dry Out feature setting.

Fail Safe Feature

The Fail Safe feature is provided to alert and respond to a loss of communication signal and/or if the sensor system stays in the active mode for a prolonged period of time. This important feature safeguards your automatic irrigation system from being inadvertently shut off for an indefinite period of time due to a sensor system malfunction.

18

Page 19 Page 21
Image 20
Page 19 Page 21
Contents User’s Guide Contents Page Getting Started Here’s all there is to itStep Receiver Module Features Installing the Receiver Module Connecting the Receiver Wires Wiring Procedure I sensor-readyWiring Procedure II no sensor feature Normally-open SensorInitial System Test Least of 15 seconds to establish communicationSensor Module Features Installing the Sensor Module 1/4 Washer Freeze Sensor Site Selection Select Temperature Scale Set Temperature Activation Threshold Twrfs models onlySelect Temperature Threshold Page Smart Bypass Feature Water Delay FeatureRefer to Sensor Module Battery Replacement on Signal Strength DisplayBattery Strength Display Dry Out Feature Fail Safe FeatureProlonged Active Mode Loss of communicationSet or Restore the Sensor Address Code Turn the Receiver Module Off and OnSensor Module Battery Replacement Unscrew and remove the bottom cap from the sensor housingTo improve signal strength TroubleshootingSolving Reception Problems Receiver display is blank Sensor module does not activate the receiver at close rangeSpecifications Toro Promise Five-year Limited Warranty FCC ID OF7TWRS
Top Page Image Contents