Toro TWRS manual Getting Started, Here’s all there is to it

Page 4

Getting Started

The wireless rain sensor system is designed for easy installation, setup and years of trouble-free operation. In most cases, the system components can be installed and fully operational within minutes. All you will need is a Phillips screwdriver and basic do-it-yourself skills.

If you have problems with any portion of the installation, or the product does not seem to function properly, refer to the Troubleshooting section on page 22 first. If the problem is not listed, or the remedy does not seem to help, call the Toro Irrigation help line at 1-877-345-8676for assistance.

Here’s all there is to it:

Step 1

Step 2

The receiver is installed and connected to your irrigation system controller.

The sensor and receiver are tested at close range to verify operation.

2

Image 4

Contents User’s Guide Contents Page Getting Started Here’s all there is to itStep Receiver Module Features Installing the Receiver Module Connecting the Receiver Wires Wiring Procedure I sensor-readyWiring Procedure II no sensor feature Normally-open SensorInitial System Test Least of 15 seconds to establish communicationSensor Module Features Installing the Sensor Module 1/4 Washer Freeze Sensor Site Selection Select Temperature Threshold Set Temperature Activation Threshold Twrfs models onlySelect Temperature Scale Page Smart Bypass Feature Water Delay FeatureBattery Strength Display Signal Strength DisplayRefer to Sensor Module Battery Replacement on Dry Out Feature Fail Safe FeatureProlonged Active Mode Loss of communicationSet or Restore the Sensor Address Code Turn the Receiver Module Off and OnSensor Module Battery Replacement Unscrew and remove the bottom cap from the sensor housingSolving Reception Problems TroubleshootingTo improve signal strength Receiver display is blank Sensor module does not activate the receiver at close rangeSpecifications Toro Promise Five-year Limited Warranty FCC ID OF7TWRS