Toro TWRS manual Loss of communication, Prolonged Active Mode

Page 21
Figure 27

Loss of communication

If the sensor system does not communicate within a 24-hour period, it will remain in its current state (Active or Monitor). To alert you to this condition, the Attention Requiredsymbol will be displayed. The Antenna symbol and current air temperature (TWRFS only) will be flashing and the signal bar indicator will be cleared. See Figure 25.

If communication is not restored within 48 hours, the receiver module will automatically revert to the Monitor mode, allowing the irrigation system to resume automatic operation. The Attention Required and Antenna symbols will flash. On the TWRFS model, the temperature is replaced with two dashes. The Water Conservation indicators will flash in unison. See Figure 26.

Prolonged Active Mode

If the sensor system remains in the Active mode for seven consecutive days, it will automatically revert to the Monitor mode, allowing the irrigation system to resume automatic operation. The Sensor Status indicator will flash continuously and the Attention Required symbol will be displayed. See Figure 27.

Note: This condition generally indicates a sensor problem. Check the sensor test spindle to make sure it moves freely. (The sensor discs must be dry for this test).

•To reset the sensor system, press the Smart Bypass button one time.

Figure 25

Figure 26

19

Page 20 Page 22
Image 21
Page 20 Page 22
Contents User’s Guide Contents Page Here’s all there is to it Getting StartedStep Receiver Module Features Installing the Receiver Module Wiring Procedure I sensor-ready Connecting the Receiver WiresNormally-open Sensor Wiring Procedure II no sensor featureLeast of 15 seconds to establish communication Initial System TestSensor Module Features Installing the Sensor Module 1/4 Washer Freeze Sensor Site Selection Set Temperature Activation Threshold Twrfs models only Select Temperature ThresholdSelect Temperature Scale Page Water Delay Feature Smart Bypass FeatureSignal Strength Display Battery Strength DisplayRefer to Sensor Module Battery Replacement on Fail Safe Feature Dry Out FeatureLoss of communication Prolonged Active ModeTurn the Receiver Module Off and On Set or Restore the Sensor Address CodeUnscrew and remove the bottom cap from the sensor housing Sensor Module Battery ReplacementTroubleshooting Solving Reception ProblemsTo improve signal strength Sensor module does not activate the receiver at close range Receiver display is blankSpecifications Toro Promise Five-year Limited Warranty FCC ID OF7TWRS
Top Page Image Contents