Toro TWRS manual Signal Strength Display, Battery Strength Display

Page 19

Signal Strength Display

This feature displays sensor signal strength on a digital scale ranging from 0.0 to 10.2

1.Press the Setup button as needed to display the antenna icon and the digital readout. The display will indicate the strength of the last received signal. See Figure 22.

Important: A signal strength value less than 2.0 is not reliable and may cause inconsistent operation. Relocate the sensor as needed to

increase the signal strength. Refer to “Resolving Reception Problems” on page 22 for additional information.

Figure 22

Battery Strength Display

This feature displays sensor battery strength on a bar scale. The strength of the battery is indicated by the height of the bar stack: No bar = a dead battery to six bars = full strength.

1.Press the Setup button as needed to display the batterysymbol and the bar scale. See Figure 23.

Note: Low battery strength is indicated when the battery symbol appears on the main display. To prevent possible loss of communication, battery replacement is recommended.

Refer to “Sensor Module Battery Replacement” on page 21.

Figure 23

17

Page 18 Page 20
Image 19
Page 18 Page 20
Contents User’s Guide Contents Page Here’s all there is to it Getting StartedStep Receiver Module Features Installing the Receiver Module Wiring Procedure I sensor-ready Connecting the Receiver WiresNormally-open Sensor Wiring Procedure II no sensor featureLeast of 15 seconds to establish communication Initial System TestSensor Module Features Installing the Sensor Module 1/4 Washer Freeze Sensor Site Selection Select Temperature Threshold Set Temperature Activation Threshold Twrfs models onlySelect Temperature Scale Page Water Delay Feature Smart Bypass FeatureBattery Strength Display Signal Strength DisplayRefer to Sensor Module Battery Replacement on Fail Safe Feature Dry Out FeatureLoss of communication Prolonged Active ModeTurn the Receiver Module Off and On Set or Restore the Sensor Address CodeUnscrew and remove the bottom cap from the sensor housing Sensor Module Battery ReplacementSolving Reception Problems TroubleshootingTo improve signal strength Sensor module does not activate the receiver at close range Receiver display is blankSpecifications Toro Promise Five-year Limited Warranty FCC ID OF7TWRS
Top Page Image Contents