Toro TWRS manual Installing the Receiver Module

Page 7

Installing the Receiver Module

Important: Installation of this product must comply with national and local building and electrical codes. For assistance, contact a professional irrigation system contractor in your area.

The receiver module is suitable for either indoor or outdoor installation. Select a location next to the controller that provides the following conditions:

•The display screen is clearly visible and the control buttons are easily accessed.

•The connection cable can reach the controller wiring terminal strip without straining.

• The antenna will be unobstructed and is able to be adjusted.

1.Install one of the provided stainless steel screws into the wall at the intended receiver location. Leave a 1/8" (3mm) gap behind the screw head. Note: Use screw anchors if installing the receiver on drywall or masonry.

2.Hang the receiver on the screw ensuring the keyhole slot drops down onto the screw shaft. Back the screw out as necessary for good fit.

3.Install a second screw through the lower tab to secure the receiver.

4.Route the connection cable through the bottom of the controller cabinet to the wiring connection terminals.

Figure 1

Important: If the receiver module is installed outdoors, be sure to keep the cover in the closed position when you do not need to view the display or access the control buttons.

5

Page 6 Page 8
Image 7
Page 6 Page 8
Contents User’s Guide Contents Page Here’s all there is to it Getting StartedStep Receiver Module Features Installing the Receiver Module Wiring Procedure I sensor-ready Connecting the Receiver WiresNormally-open Sensor Wiring Procedure II no sensor featureLeast of 15 seconds to establish communication Initial System TestSensor Module Features Installing the Sensor Module 1/4 Washer Freeze Sensor Site Selection Select Temperature Threshold Set Temperature Activation Threshold Twrfs models onlySelect Temperature Scale Page Water Delay Feature Smart Bypass FeatureBattery Strength Display Signal Strength DisplayRefer to Sensor Module Battery Replacement on Fail Safe Feature Dry Out FeatureLoss of communication Prolonged Active ModeTurn the Receiver Module Off and On Set or Restore the Sensor Address CodeUnscrew and remove the bottom cap from the sensor housing Sensor Module Battery ReplacementSolving Reception Problems TroubleshootingTo improve signal strength Sensor module does not activate the receiver at close range Receiver display is blankSpecifications Toro Promise Five-year Limited Warranty FCC ID OF7TWRS
Top Page Image Contents