６Ｆ８Ａ０８７０
2. Overview
The LF414/LF600F, LF414/LF610F, LF414/LF620F and LF414 electromagnetic flowmeter can be use in the following hazardous (classified) locations.
ClassⅠ, Division 2, Groups A, B, C and D,
ClassⅡ, Division 2, Groups E, F and G
ClassⅢ
This product is a converter used for electromagnetic flowmeters that measure the volumetric flow rate of conductive fluid using Faraday's law of electromagnetic induction.
You can bring out the functions of the converter when you place it in the converter housing you prepare and use it in combination with a fluid rate measurement detector.
The converter sends out a signal to drive the detector excitation coil, which generates a magnetic field inside the detector. The converter receives the signal electromotive force obtained by the detector. The signal electromotive force is proportional to the generated flow rate in the fluid using Faraday's law of electromagnetic induction. After carrying out its operation, the converter converts the signal electromotive force to an analog signal output and displays the status, as a flow rate value.
Features
With a linear relationship between the flow rate and output signal, the electromagnetic flowmeter is used as an
(1)Wide flow velocity range setting, such as a flow velocity range of 0 to 0.3 ft/s and 0 to 32.8 ft/s (0 to 0.1 and 0 to 10m/s) is achieved.
(2)The unique Noise Sentry filter circuit enables you to obtain stable output automatically.
(3)Full graphic LCD that enables display of a large amount of information
With a large amount of a maximum of 14 characters x 8 lines, you can easily set up various displays including bar graphs and alarm indications.
The backlight display allows you to read the indicator easily.
(4) Use of infrared switches
Use of infrared switches allows you to perform various operations, without opening the converter housing cover.
(5)Intelligent functions
The widely used HART protocol communications system is used as a standard feature. This product supports PROFIBUS*2 communication (optionally available).
*1 HART protocol: “HART” stands for Highway Addressable Remote Transducer and is a communication protocol recommended by HCF (HART communication Foundation) for industrial sensors.
*2 PROFIBUS:PROFIBUS, which stands for PROCESS FIELDBUS, is a field bus that is approved by international standard IEC61158. The electromagnetic flowmeter supports PRFIBUS PA for process automation.