Orion 2xx Position the Jupiter transmitter on the side of the MLI, Internal, Direct Insertion

2.	Position the Jupiter transmitter on the side of the MLI
	where it will be attached. Mark the location and the exact
	area where the clamps will be attached to hold the Jupiter
	in place.
3.	Attach the lower clamp and tighten so that it remains in
	place, but loose enough so that there is still room to place
	the guide tab from the Jupiter between the inside of the
	clamp and the outer diameter of the MLI chamber. See
	Figure 1.
4.	The upper clamp will need to be open to a large enough
Upper Clamp	diameter to be able to mount to the MLI as well as the
	probe. The upper clamp should be positioned just above
	the 3⁄4" NPT threads. See Figure 2.
5.	Mount the Jupiter guide pin in the lower clamp and tight-
	en. If necessary, use strapping tape to temporarily hold in
	place on the MLI. See Figure 1.
6.	Position the upper clamp to attach the unit to the MLI
	and tighten. See Figure 1.
7.	Discard any tape temporarily holding the Jupiter to the
Figure 2	MLI.
2.4.2	Internal, Direct Insertion

Up

Bottom view

Figure 3

Float Attachment Detail

Use caution when handling probes to ensure probe is not bent during installation. A bend in the probe may prevent float from traveling freely up and down the probe.

1.Verify float will pass through vessel opening, if not, it will be necessary to attach the float after the probe is installed.

2.Carefully insert probe into vessel and thread or bolt to the mating connection as appropriate.

3.The float is held on the probe by a C-clip inserted into a groove machined into the tip of the probe. The float is attached or removed by removing and reinserting the C-clip. See Figure 3. To ensure proper float orientation, the float is marked “Up➞”.

7 46-649 Jupiter Magnetostrictive Transmitter - FOUNDATION fieldbus™