2.3Before You Begin
Caution: This instrument is intended for use in Installation Category II, Pollution Degree 2 locations.
2.3.1Site Preparation
Each Jupiter magnetostrictive transmitter is built to match the specifications required within the defined model option number. Wiring terminations will need to be made and the configuration will need to be accomplished.
Ensure that the power to be supplied to the instrument is the same voltage (24 VDC) as ordered with the instru- ment, and that the wiring between the power supply and the Jupiter transmitter is correct for the type of installa- tion. See Specifications, Section 5.3.
NOTE: Applying incorrect voltage will damage the unit.
When installing the Jupiter transmitter in a general purpose or hazardous area, all local, state, and federal regulations and guidelines must be observed. See Wiring, Section 2.5.
2.3.2Equipment and Tools
For installation of a new Jupiter with magnetic level indi- cator set, refer to Orion Instruments instruction manual
To attach a Jupiter transmitter to an existing MLI or direct insertion model, you may need the following tools:
•5⁄16"
•Screwdriver and assorted hand tools for making conduit and electrical connections.
•Digital multimeter or DVM to troubleshoot supply voltage problems.
5 |