Left Hand | Screws | Idler |
|
|
|
| Electric | ||
| Pulleys | Spring | ||
|
| |||
Cover |
| Primary | Clutch | |
| Idler | Arm | Pulley | |
|
|
Bolt in
Housing
Left
Hand
Mandrel
Mower
Drive Belt
Belt
Keepers
TO REPLACE MOWER BLADE DRIVE
BELT
Park the tractor on level surface. Engage parking brake.
1.Remove mower drive belt (See "TO REPLACE MOWER DRIVE BELT" in
this section of this manual),
2.Remove mower (See "TO REMOVE MOWER" in this section of this
manual).
3.Remove screws from R.H. mandrel cover and remove cover. Unhook spring from bolt on mower housing.
4.Carefully roll belt off R.H. mandrel pulley.
5.Remove belt from center mandrel pulley, idler pulley, and L.H. mandrel pulley.
6.Remove any dirt or grass which may have accumulated around mandrels
and entire upper deck surface.
7.Check secondary idler arm and idler to see that they rotate freely.
8.Be sure spring is hooked in secondary idler arm and
9.Install new belt in lower groove of L.H. mandrel pulley, idler pulley, and
center mandrel pulley as shown. 10.Roll belt over R.H, mandrel pulley. Make sure belt is in all grooves
properly.
11.Reconnect spring to bolt in mower
housing and reinstall R.H. mandrel cover.
12.Reinstall mower to tractor (See
"INSTALL MOWER AND DRIVE BELT" in the Assembly section of this manual).
•Reassemble mower drive belt (See
"TO REPLACE MOWER DRIVE BELT"
in this section of this manual).
Left | Center |
|
Hand | Mower Blade Mandrel |
|
Mandrel | Drive Belt | Right Hand |
|
| Cover |
|
| Mandrel |
td,erAm/
?pring" / _u_l'e;
Bar Bracket Screw
TO ADJUST ATTACHMENT CLUTCH
The electric clutch should provide years of service. The clutch has a
that stops the pulley within 5 seconds. Eventually, the internal brake will wear which may cause the mower blades to not engage, or, to not stop as required. Adjustments should be made by your nearest authorized service center/
26 department.